Hampton Bay CIL1693M Installation guide

○

ASSEMBLY INSTRUCTION

SKU#250-336

Note: Please consult a qualified electrician if you are not certain of the installation.

CAUTION: Before starting the installation, disconnect the power by turning off the circuit breaker or by

removing the fuse at the fuse box. Caulk to mounting surface at top and sides.

1. Fasten cross bar onto outlet box with 2 outlet box screws provided.

2. Connect wires white to white and black to black. Cover connections using wire connectors provided. Tie

ground wires from outlet box and from fixture to ground screw on cross bar.

3. Place fixture body against wall by aligning the protruding mounting screws all the way through wall plate

and tighten fixture using 2 lock nuts provided. Fasten fixture until it is held firmly to the wall.

4. Place top cover, top cap over nipple of finial A, and then fasten finial A down to the tube A.

5. Fasten finial B into tube B.

6. Install the bulbs (included).

7. Place decorative pan, fixture frame over short nipple. Fasten them with the bushing.

8. Screw the long nipple into the bushing. Place bottom cover over long nipple, and fasten it with the finial C.

Download PDF