Hampton Bay CBW1612M-BRZ Operating instructions

○

ASSEMBLY INSTRUCTION

SKU# 253-536

NOTE: Please consult a qualified electrician if you are not certain of the installation.

CAUTION: Before starting the installation, disconnect the power by turning off the circuit

breaker or by removing the fuse at the fuse box. Caulk to mounting surface at top and sides.

1. Fasten cross bar onto outlet box using 2 outlet box screws provided.

2. Screw finial 2 into the fixture as drawn.

3. Screw the nipple into the bushing located at the bottom of the fixture.

4. Install the bulbs (included).

5. Place glass shade, decorative pan and top cover over the nipple onto the fixture and fasten them

using finial 1.

6. Connect the wires white to white and black to black. Cover the connections using wire

connectors provided. Tie the ground wires from outlet box and from fixture to the ground screw

on the cross bar.

7. Place fixture body to the wall by aligning the protruding mounting screw all the way through the

wall plate and tighten the fixture using 2 lock nuts provided until it is held firmly on the wall.

8. Turn on the power.