Jade Bath BA1816-67 Operating instructions

Jade Bath
Brand
Jade Bath
Model
BA1816-67
Type
Operating instructions
1.50
23.50
5.00
57.75
4.50
17.00
Ø 3.00
66.75
19.00
31.75
3.00
45.00
3.00
Ø 2.75
Jade Bathrooms Products Inc.
11900 J.J. Joubert, Suite B, Rivière des Prairies, Québec, Canada, H1E 7E7
Tel: 514-832-0555 • Fax: 514-832-0554 • www.jadebath.com
Customer Service: 866-333-0555
1
Capri 1018
Installation Procedure
Professional Installation Recommended
TUB DIMENSIONS
Free Standing Tub
ATTENTION:
Please inspect the tub carefully for any
defect or damage before installation.
Once installed, any defect or crack will
not be under warraty.
1) Floor must be flat & level.
2) Floor must be built to support 65-lbs per
square foot load.
3) Delicately unpack the tub and inspect for
any defect or damage before installation.
4) See dimensional drawings to locate drain
position.
BEFORE INSTALLATION
Jade Bathrooms Products Inc.
11900 J.J. Joubert, Suite B, Rivière des Prairies, Québec, Canada, H1E 7E7
Tel: 514-832-0555 • Fax: 514-832-0554 • www.jadebath.com
Customer Service: 866-333-0555
2
Capri 1018
Installation Procedure
• Use liquid detergent & soft cloth to clean bathtub regularly.
• Do not use detergent containing acetone or ammonia. Also do not use abrasives or
detergents containing chemical solvent or solid particles; it could easily scratch.
• To repair scratches in the acrylic, use #1500 wet polishing sand paper to grind. Subse-
quently, use a cloth with car wax to polish the scratch to obtain a glossy finishing.
• To remove joint compound, use a plastic or wood spatula wrapped with a damp cloth. Do
not use any metal tool or brush.
• If a rubber mat is used inside the tub, it is necessary to remove it after every bath. Other-
wise, potential damage could be caused and will not be covered by warranty.
GENERAL TUB MAINTENANCE & REPAIR
CONGRATULATIONS!!!
Now your Tub should be ready for use! Enjoy your bath!
If you have any questions, feel free to contact us
at the Customer Service: 866-333-0555
DRAIN & OVERFLOW SYSTEM
PLEASE NOTE: The Drain & Overflow System is already
installed. The following illustration is for informational
purposes only.
TUB INSTALLATION
1) Prepare the piping to connect to the drain.
(Professional Installation Recommended)
2) Verify the fitting to connect the drain.
3) Once the pipe under the floor is ready put
the tub in place and connect underneath.
4) Proceed to finalise piping connections.
Free Standing Tub
  • Page 1 1
  • Page 2 2

Jade Bath BA1816-67 Operating instructions

Jade Bath
Brand
Jade Bath
Model
BA1816-67
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents