2. Feiss
  3. OL5407

Feiss OL5407 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Feiss OL5407 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
(E) 4/07
ASSEMBLY INSTRUCTIONS FOR OL5407, OL5408
Bulb
(not included)
Candle
Tube
Top Cover
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Rubber Washer
Center Pipe
Main Frame
Socket
Post Cup
Post
(not supplied)
Sheet Metal Screw
Fixture Wire
Fixture Ground Wire
Supply Wire
Supply
Ground Wire
Finial
Carefully unpack and identify all parts before
assembly. Bulb is not included.
1. Slip candle cover tube onto sockets.
2. Install light bulb (Not Included). See relampinglabel
located at socket area for type and maximumallowed
wattage.
3. Screw center pipe onto center body. Note correctposition
of center pipe as shown in illustration.
4. Slip the top cover, and rubber washerthrough the
installed center pipe. Lock them alltogether by fastening
with finial.
5. Electrical installation onto post: If you arereplacing an
existing fixture, disconnect andremove the old fixture.
A) Slip post cup over post. Mark position ofholes in post cup
on post.
B) Remove post cup and expose the supplywiring from above
post. Drill 1/8" (3mm)diameter pilot holes in post at
places wheremarked.
C) Make wire connections. (wire connectors notprovided).
Refer to chart below for correctconnections. Wire supply
wires to fixture wiresaccordingly.
D) Connect ground wire from supply source tofixture ground
wire with connector. Neverconnect ground wire to black
or white powersupply wires. Carefully place wires inside
post.
E) Slip post cup onto post. Align holes in postcup with holes
in post. Attach post cup to postwith sheet metal screws.
Tracer Wire
*Note: When parallel wire (SPT 1 & SPT2)
is used. One wire is square shaped or
ridged and the other wire will be round
in shape or smooth. (See Illustration)
Connect Black Fixture Wire to:
Black Supply Wire or
*Parallel cord
(round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire
(other than green)
with copper conductor
Connect White Fixture Wire to:
White Supply Wire or
*Parallel cord
(square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire
(other than green)
with silver conductor
/