Kichler Lighting 43996OZ, 43996CH, 43996NI User manual

  • Hello! I am an AI chatbot trained to assist you with the Kichler Lighting 43996OZ User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Date Issued: 06/14/16 IS-43996-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse
box before starting and during the installation.
1) Pass fixture wire and ground wire thru desired amount of
stems D & E and thread together using supplied nipples.
NOTE: Use a drop of Thread compound (supplied) on the
threads.
2) Thread Swivel onto stems securely. Pass threaded Swivel,
wire, ground wire thru hole in canopy. Place lockwasher
onto end of threaded nipple protruding from inside canopy.
Thread hexnut onto threaded nipple protruding from inside
canopy if not already completed by factory. Tighten to
secure Swivel.
3) Find the appropriate threaded holes on mounting strap. As-
semble mounting screws into threaded holes.
4) Attach mounting strap to outlet box. Mounting strap can be
adjusted to suit position of fixture.
5) Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a
hole and two raise dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Put
ground wire from outlet box under cupped washer and
green ground screw and thread screw into hole in
mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector,
after following the above steps. Never connect ground wire
to black or white power supply wires.
6) Make wire connections. Reference chart below for correct
connections and wire accordingly.
7) Push fixture to ceiling, carefully passing mounting screws
through holes in canopy. Make sure all wires are inside
canopy and do not get pinched between canopy and
ceiling.
8) Thread lockup knobs and lockwashers onto mounting screw
and tighten to secure fixture to ceiling.
9) Place glass over socket and take the glass retainer and
socket ring and thread onto the socket to secure glass in
place.
10) Screw light bulb (not supplied) in place.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
OUTLET BOX
WIRE
CONNECTORS
STRAP
MOUNTING SCREW(S)
MOUNTING
STRAP
MOUNTING
SCREWS
CANOPY
LOCKWASHER
LOCK-UP KNOB
SWIVEL
E
D
SOCKET
GLASS
FLAT
COVER
SOCKET RING
/