1.Attach the nipple-1 to the mounting strap, and secure with the lock nut
and washer.
2.Attach the mounting strap to wall box using 2 mounting srews.
3.Make wire connections with wire nuts:
---Connect black wire from fixture to black wire from power source.
---Connect white wire from fixtuer to white wire from power source.
---Attach the grounding wire and house grounding wire to mounting strap
with a green grounding screw.
Carefully tuck wires back into the wall box.
4.Attach the wall plate to the mounting strap by inserting the nipple-1, and
secure with the end cap.
5.Place the glass shade to the wall plate, which must be against the metal
ring to avoid wobble.
6.Thread the nipple-2 into the hex nut, attach the metal cap onto the
nipple-2, and secure with the finial.
7.Install bulbs. (Please do not exceed the maximum capacity, which is
recommended on the package.)
8.Turn on the power at fuse or circuit box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1.Before installing, consult local electrical codes for wiring and grounding requirements.
Socket
Metal Ring
End Cap
Metal Cap
Hex Nut
Nipple-1
Finial
Glass Shade
Wall Plate
Mounting Strap
Wall Box
Washer
Lock Nut
Wire Nut
Grounding Screw
Fixture Wire
Grounding Wire
Mounting Screw
WS8171
Installation Steps
Nipple-2
/