Page is loading ...
Proximity card reader – Installation manual
All rights reserved. © AAT HOLDING S.A. 2
1. Introduction
KDH-C100U/KDH-C100H/KDH-C100M KDH-C110U/KDH-C110M
Proximity card readers type KDH-C100U_H_M & KDH-C110U_M are designed for
use in access control systems. Models C100 can be installed inside or outdoors, C110—
indoor only. They have housing made of ABS plastic. Readers are designed to work with
controllers with Wiegand interface. The devices reads the card Unique (125 kHz), HID
Prox (125 KHz) or Mifare Classic (13.56 MHz), depend of model. Switchable Wiegand
format makes this product universal for various installations. The range of the proximi-
ty card reading is from 2 to 10 cm depend of the model and type of card.
Characteristics reader
- To work with controllers with Wiegand port
- Proximity card types - Unique, HID Prox 26 bits (125 kHz) or
Mifare Classic (13.56 MHz)
- For indoor and outdoor installation (models C100 series only)
- Built-in sounder and optical-red/green LED
- Power supply 12 VDC
Technical specifications
Name of parameters or function Parameters value or description
- Supply power 12 VDC +/- 10%
- Current load < 60 mA
- Proximity card read range Od 2 do 10 cm (depend of model and card type)
- Card type UNIQUE, HID Prox (125 kHz), Mifare (13,56 MHz)
- Switched Wiegand card format 26/34 (Unique, Mifare), 26 i 37 (HID Prox) auto.
- Wiegand port D0, D1
- Environments For indoor and outdoor (C100 series only)
- Operating temperature range Od –40°C do +60°C
- Operating humidity range 10% - 95% RH
- Dimensions: KDH-C100U_H_M
KDH-C110U_M
103 x 48 x 19 mm
84 x 84 x 19 mm
Proximity card reader – Installation manual
All rights reserved. © AAT HOLDING S.A. 3
Color Function Description
Red VCC + Power + 12 VDC
Black GND Power - 12 VDC
Green D0 Wiegand Data 0
White D1 Wiegand Data 1
Gray SW Switched format, 26 default, to GND–34
Blue LED Green LED
Yellow Buzzer Buzzer
Wiring Diagram
READER INSTALLATION
Separate the back cover with holes and use as a template
Drill 2 holes (A, C) in the wall of the bolt and one under the cable
Insert the bolt holes (A, C) attached dowels
Screw the rear part of the housing to the wall using the screws
Bring out the controller cables through the hole (B)
Mount the reader on the base and secure it from below with a screw
Red
Black
Green
White
Blue
Yellow
Step 1 Step 2 Reader Step 3 Controller
Wall
Model KDH-C100H
Models KDH-C100U / KDH-C100M / KDH-C110U / KDH-C110M
60mm
30mm
Red
Black
Green
White
Blue
Yellow
60mm
Step 1 Step 2 Reader S tep 3 Controller
v
v
v
v
Wall
KDH-C100
KDH-C110
Gray GND - W34
GND - W34
Gray
KDH-C110
70mm
KDH-C100
/
