To see the complete LAUFEN range go to
www.reece.com.au/bathrooms
LAUFEN
TWINPLUS SHOWER/BATH MIXER
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from
their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs
listed are correct at time of publication however the manufacturer/distributor takes no responsibility for
printing errors.
Tech Page Version 2
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Conditions.
Dimensions are nominal measurements only.
TM
WMK25894
AS/NZS 3718
SPECIFICATIONS
Recommended use Domestic, Hotel and Commercial
Colour availability Chrome
Pressure rating Maximum continuous operating pressure 1000kPa.
As per AS/NZS3500 pressure must be limited to
500kPa on any new home, extension or renovation.
For best performance and longer life we recommend
150-500kPa.
Hot and cold water inlet pressure should be equal.
Temperature rating Maximum continuous working temperature 80°C
Suitable Hot Water
Units
Storage Tank: Yes
Continuous Flow: Yes
Gravity Feed: Not suitable
page 1 of 4
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Important Note
Mixer must be installed to the requirements of AS/NZS 3500 by a qualified plumber. Your mixer comes to you already factory
assembled and tested. We do not recommend the dismantling of any internal part of the mixer. The mixers are factory tested and
sealed so as to give the best performance.
TWIN PLUS SHOWER/BATH MIXER
INSTALLATION INSTRUCTIONS
1
2
3
4
5
Turn off the stop-cocks before working on
the elements
Factory setting
Input/Output inverters
page 2 of 4
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
TWIN PLUS SHOWER/BATH MIXER
2
3
6 Nm
+/- 1 Nm
Tighten the 2 screws parallel (1 turn each side)
Check before installation that all seals are available and at the right place
page 3 of 4
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
TWIN PLUS SHOWER/BATH MIXER
Before installing the decor, open the valves and check for
water tightness
Only for Simibox Light without stop valves
1
3
2
4
5
Examples of how to fit the decorative elements
page 4 of 4
SIMIBOX LIGHT W/O SHUT-OFF
To see the complete LAUFEN range go to
www.reece.com.au/bathrooms
LAUFEN
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade
people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without
prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of
publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Conditions.
Dimensions are nominal measurements only.
TM
WMK25894
AS/NZS 3718
page 1 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Important Note
Mixer must be installed to the requirements of AS/NZS 3500 by a qualified plumber. Your mixer comes to you already factory
assembled and tested. We do not recommend the dismantling of any internal part of the mixer. The mixers are factory tested and
sealed so as to give the best performance.
SIMIBOX LIGHT W/O SHUT-OFF
INSTALLATION INSTRUCTIONS
Simibox Light
Hot water = left
Simibox Light
Cold water = right
HOT COLD
G 1/2
G 1/2
Upper outlet
To close off the unused outlet, fit the plug and check the seal.
Lower outlet
Hot water
Cold water
Connection to the water mains
page 2 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
SIMIBOX LIGHT W/O SHUT-OFF
Connection to the water mains
Cold or mixed water Mixer
Purge from the front
7.81038.000.000
Hot waterCold water Cold water
Plug/gasket x 2
Thin wall
The mounting flanges are adjustable according to the depth of the housing
Thick wall
Fitting the flanges
page 3 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
SIMIBOX LIGHT W/O SHUT-OFF
The front face of the tiling must lie between the min. and max. dimension shown on the label
mm
25
Front face of the tiling
Use the mounting flanges as drilling template
It is recommended to use at least 4 fixing
points (Ø 5 screws) to fix the appliance into or
onto the wall. For front wall installation, it is
strongly recommended to use 8 x M5 screws
Position and align the built-in unit using a spirit level
Pre-installation
page 4 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
SIMIBOX LIGHT W/O SHUT-OFF
Embedded in the wall with fixing rails
Cold water = right
Embedded in the wall
Surface mounting
Simibox Light
Hot water = left
Simibox Light
Remote installation on the wall with flanges
(each flange 8 mm thick)
Examples of installation
page 5 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
SIMIBOX LIGHT W/O SHUT-OFF
Installation with supporting frame
Installation behind a prefabricated wall
Examples of installation
Pressure test and network purging
Both exits must be purged
Purge through the outlets Purge from the front
OPTION 9.20793.903.001
Rinsing device with stop-cock
Pressure test
While still accessible, the water pipes
must be subjected to a pressure test. The
resistance pressure of the concealed body
Simibox) is PN 10,
current local instructions
page 6 of 7
LAUFEN
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
SIMIBOX LIGHT W/O SHUT-OFF
If necessary put a silicone seal between the wall and the box
Coat the wall with adhesive and fit the sealing cu
Apply the wall decoration
Take the lid off and cut the plastic case flush with the wall using a cutter
Finishing
page 7 of 7
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Wolfen 2264795 Installation guide
-
-
Kado 9501530 Technical Guide
-
Caroma Contura Installation guide
-
Armitage Shanks PORTMAN21 Installation guide
-
ROGERSELLER 3606003601 Installation guide
-
ALDER TAPWARE Vito Bertoni Series User manual
-
Parmco LS-SLIM Owner's manual
-
ROGERSELLER 3606014501 Tonic Up Wall Mixer and Basin Outlet User manual
-
Solargain IHE-315GL-30 User manual
