2. Teeter
  3. EZ-Angle Tether

Teeter EZ-Angle Tether User guide

  • Hello! I've reviewed the user instructions for the TEETER EZ-Angle Tether Strap. This document covers how to assemble the strap, adjust it for different inversion angles using the sliding buckle and colored markers, or remove it for full inversion, and i am ready to answer your questions.
  • How do I assemble the tether strap?
    What do the colored markers indicate?
    How can I achieve a full inversion?
No strap
Green
Orange
Red
• Remove the pre-assembled clip from the strap loop. Hold the tether strap with markers facing
up and insert the strap loop through the FRONT of the designated loop on the A-Frame.
• Without pulling the strap entirely through the loop, insert the strap loop through the bottom
opening of the buckle, and then again through the top opening.
• Continue pulling on the tip of the strap loop until tted snugly around the A-Frame crossbar.
• Slide the buckle so that your desired colored marker shows through the center of the buckle
Hook the clip to the strap loop and secure at the base of the table bed.
Specications subject to change without notice. © COPYRIGHT 2017; International law prohibits any copying. Made in China. LF7010 0517-2
User Instructions
EZ-Angle™ Tether Strap
Assembly
Easy-to-Use
EN
(only necessary if the tether strap is not pre-assembled.)
Slide the buckle to the...
800.847.0143 | teeter.com
• Green marker for inversion to a gentle 200.
• Orange marker for inversion to a moderate 400.
• Red marker for inversion to a more advanced 600.
• OR remove the tether strap entirely for full inversion, stretching and exercise!
GREEN
20 Degrees
Strap Loop
Clip
Sliding Buckle
RED
60 degrees
ORANGE
40 degrees
/