2. FLEXCO
  3. Flex-Lifter Transport Cart

FLEXCO Flex-Lifter Transport Cart Operating instructions

  • Hello! I have reviewed the Installation Instructions for the Flex-Lifter transport cart. This document outlines how to assemble the cart by attaching the wheel frame and handle. It also explains how to properly store the handle and remove the wheel kit before use. I'm ready to assist you with any questions you have about setting up your Flex-Lifter.
  • How do I install the wheel frame?
    Where do I store the handle when not in use?
    What should I do before using the Flex-Lifter?
Installation Instructions - Flex-Lifter™ Transport Cart
1. Remove pin and hairclip from trough brace
at one end of Flex-Lier™ (Fig. 1).
Fig. 1
Fig. 3 Fig. 4
Fig. 2
Align notch
with pin hole
Wheel Frame
Remove hairclip
Store cart handle
in wheel frame
tube
Slide handle
into trough
brace hole
Hairclip
Pin
2. Slide wheel frame into tube until notch in
wheel frame aligns with the pin hole (Fig. 2).
3. Reinsert pin and hairclip.
4. Install handle on opposite end of Flex-Lier
by removing one hairclip, sliding handle into
trough brace hole, and reinserting hairclip
(Fig. 3).
5. Turn Flex-Lier over, li by handle, and
pull to desired location (Fig. 4).
6. Remove wheel kit and handle before using
Flex-Lier. NOTE: Store handle inside
wheel frame tube (Fig. 4).
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@exco.com
Visit www.flexco.com for other Flexco locations and products.
©2014 Flexible Steel Lacing Company. 09/14. For reorder: X1960
/