17
SERVICE MANUAL
Model:AFD631GW/GB/GR
17
Issue 201003
Rev. Ref11003S006V0
(2) Locking/unlocking
The G icon is displayed, indicating that the panel is under locking status. At this time, by pressing the
B5 "OK" key and holding it for 3 s, the G icon disappears, such that the panel can be unlocked. By
pressing the B5 "OK" key again and holding it for 3 s, the G icon is displayed, such that the panel can
be locked again.
(3) Refrigerating chamber temperature adjustment (2~8 ) (operation under unlocking status)
After the Menu key is pressed, the set value A icon of the original refrigerating chamber starts blinking,
entering the refrigerating chamber temperature setting mode.
Afterwards, when adjusting the B3 key, the temperature value increases by 1 each time the B3 is
pressed, recycling among 02~08~OF. Press the OK key to determine the selection. When the
refrigerating chamber is set at the OF position, the refrigerating chamber is deactivated; when it is set
at other temperature positions, the refrigerating chamber is activated and refrigerating. If the key
operation is not performed within 5 s or other keys are pressed during the adjustment, then the set
value is not confirmed and is returned to the original set position.
(4) Freezing chamber temperature adjustment (-16~-24 ) (operation under unlocking status)
Select the freezing temperature settings via the Menu key, the original freezing chamber set
temperature icon B starts blinking, entering the freezing chamber temperature setting status.
Afterwards, the freezing chamber temperature decreases by 1 each time the B3 is pressed, recycling
between -16~-24. Press the OK key to determine the selection. If the key operation is not performed
within 5 s or other keys are pressed during the adjustment, then the temperature set value is not
confirmed and is returned to the original set position.
(5) Timing setting:
1. When dispatched from the factory, the timing region displays "00", the "alarm clock" icon does not
light up, without entering the timing status.
2. Under the unlocking status, by selecting the "Menu" key to select the timing region, the figure "00"
blinks. Then, press the "adjust" key to set the timing to "00" ~ "99" ~ "00". By pressing the "adjust" key,
the timing increases by 1; by keeping on pressing the "adjust" key, the timing increases by degrees
quickly at a certain speed to the time of completion of the selection. Each time the "timing" key is
pressed, the buzzer beeps once. By pressing the "OK" key to confirm the start of countdown, the
"alarm clock" icon is displayed.
3. When the countdown goes to "00", the figure "00" blinks and the buzzer alarms once for every 5 s
and stops alarming after 3 times or after the user presses any key, such that the figure stops blinking
and the "alarm clock" icon extinguishes.
4. Special function 1: if time adjustment is required by the user during the countdown, by selecting the
"Menu" key to select the timing region, the figure blinks, and then by pressing the "adjust" key, the
figure changes and recycles from the currently displayed time to "99"~"00"~"99", and after the
adjustment is done, the countdown starts by pressing the "OK" key to confirm.
5. Special function 2: if timing is required to be stopped by the user during the countdown, first by
selecting the "Menu" key to select the timing region and pressing the "adjust" key, the figure blinks and
is adjusted to "00" via the "adjust" key, and by pressing the "OK" key to confirm, the "alarm clock" icon
extinguishes to exit the timing function.