Page is loading ...
INSTRUCTION MANUAL
ES-60W Version 1.0 1/1
ES-60W
WARNING:
Installation by qualified personnel only.
Speakers must be wired in parallel and connected to the
correct line terminals of amplifier.
Ensure that all speakers have the same polarity with
respect to each other.
Do not select another tapings if the speaker is in use.
No naked flame sources, such as lighted candles,
should be placed on the apparatus
.
Unused connection wires should be isolated.
PENDANT SPEAKER
SPECIFICATIONS
Model ES-60W
Speaker 6” full range
Output power RMS 60 W
Power taps 100 V 60 W, 30 W, 20 W, 15 W, 10 W & 7.5 W
Impedance 165 Ω, 330 Ω, 500 Ω, 670 Ω, 1k Ω & 1,3 k Ω
Sensitivity SPL (1 W / 1 m) 102 dB
Sound pressure SPL (60 W / 1 m) 120 dB
Frequency range 100 ~ 13.000 Hz
Dimensions (mm) Ø 385 x 302 mm
Weight 3,4 kg
Finish High impact ABS
Color White
Mounting Pendant by three hooks
Power selection Connection wires
Color Impedance 100 V
Green 165 Ω 60 W
Blue 330 Ω 30 W
Brown 500 Ω 20 W
Yellow 670 Ω 15 W
Red 1 kΩ 10 W
White 1,3 kΩ 7,5 W
Black - Common
MOUNTING AND POWER SELECTION
• Cut out a 5 mm hole in the ceiling.
• Install a hook at about 10 mm of the hole.
• Use the three steel wires to secure the speaker into the ceiling
by using the hook.
• Pass the speaker wires through the ceiling hole and connect
them to the corresponding amplifier terminals.
/