Supercedes: NEW
Page 1 of 2
BrightStat
User Interface Quick Start Guide
Manual 2100-679
Date 8-29-18
Date
Time
Blower Operation
Adjust by pressing the Fan Mode
button on the bottom
Auto Low Medium High
Current System Mode
Cooling Heating Auto Off
Up Arrow
Press to raise temperature setpoint
Temperature Setpoint
Current Temperature
Room Indoor Humidity
Outdoor Temperature
(if outdoor sensor is used)
Down Arrow
Press to lower temperature setpoint
System Mode
Select system mode
Temperature Units
Switch between Celsius or Fahrenheit
Help
Tap to view the help screen
Language
Tap to select preferred language
Fan Mode
Select fan mode
Occupancy Status
NOTE: Some of the parameters below are model dependent and may not appear on all room controllers.
General Notes
1. When any change is made to a parameter (temperature setpoint, fan setting, etc.), the value is automatically saved
in the room controller’s memory.
2. Arrows, when pressed for more than 2.5 seconds, scroll up or down at higher speed.
BrightStat
Manual 2100-679
Page 2 of 2
68.0
F
7
F7
F
7
73.0
68.0
F7
On/Off shows during
heating or cooling mode
only. Use this button to
quickly stop or start the
system in the desired
mode.
The date and time will
appear only if properly set.
Automatic Heating/Cooling Mode
In Auto mode, the setpoint located
directly under the blue line represents the
temperature which, when reached, will
trigger the system to enter cooling mode.
Similarly, the setpoint located directly above
the red line is the temperature which, when
reached, will put the system into heating
mode.
During setpoints adjustment, the large digits
are temporarily used to display the Cooling or
Heating Setpoints.
Normal temperature display resumes after
the setpoints are adjusted and the adjusted
heating and cooling setpoints are displayed in
the setpoint bar.
Cooling Only or Heating Only Mode
In Cooling Only or Heating Only mode, the
value displayed in the setpoint bar is the
current heating setpoint. To adjust it, use the
up and down arrows.
During setpoint adjustment, the large digits
are temporarily used to display the new
setpoint.
Normal temperature display then resumes and
the actual occupied setpoint is
displayed in the setpoint bar.
Fan Mode displays the blower operation
choices (Off, On, Auto and Smart).
Tap to switch between Auto,
Cooling, Heating and Off modes.
Variations
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Bard Watch TCS22-***-003 User manual
-
-
-
-
-
-
-
-
-
Other documents
-
Johnson Controls TEC2103-2 Installation Instructions Manual
-
-
-
-
-
-
York YK-ZCU4x0-0 User manual
-
-
-