Microdia MMCplus Operating instructions

Type
Operating instructions
MICRODIA Ltd
Website: http://www.microdia.com
MMCplus
TM
MEMORY CARD
OPERATING MANUAL
SPECIFICATIONS CONFIRMATION OF PARTS LIST
Dimension: 32 (L) x 24 (W) x 1.4 (T) mm
Weight: Approx. 2g
Operating Voltage: 2.7V to 3.6V
Operating Temperature:
-25°C to +85°C
Clock Frequency: Minimum 2.4 MB/sec
Operating Humidity: 5% to 96% RH
MMCplus
TM
memory card Plastic Case Manual
NOTE: Specifications are subject to change without notice.
REMOVAL of the MMCplus
TM
CARD from BLISTER
1. Hold a corner of the blister.
2. Clap the blister on your palm for removing the
plastic case.
3. Hold the blister upside down with about an inch
of distance between the blister and the table.
4. Use your finger to push the edge of the
MMCplus
TM
card.
5. Then MMCplus
TM
card will drop on the table.
Step 1 & 2 Step 3 & 4 Step 5
REMOVAL AND STORAGE OF THE MMCplus
TM
CARD IN PLASTIC CASE
1. Hold the case with both hands when opening and closing.
2. Unlock and open the lid of the case.
3. Store or remove the MMCplus
TM
card in the tray. Ensure the
card is placed properly on the tray before closing the case.
4. Lock the plastic case.
Step 2 Step 3
PRECAUTIONS FOR HANDLING AND STORAGE
Keep out of the reach of children. Get medical advice immediately if swallowed.
Do not touch the interface pin directly by hands, metal or hard objects.
Do not modify or disassemble the MMCplus
TM
card.
Do not wet, heat/fire, impact, drop or bend the MMCplus
TM
card.
Do not use or store in a humid and dusty place; in hot place such as inside a hot car, under a blazing sun, near
fire, a stove, an air-conditioner outlet, etc.
Do not expose to strong magnet fields, electrical noise and put near corrosive chemicals/gas. This may cause
damage through melting or the emission of heat/smoke or cause product failure.
Do not place in cooking appliances such as microwave ovens or high-pressure containers.
Do not detach the label on the MMCplus
TM
card. Do not attach other stickers/labels on the MMCplus
TM
card.
DATA PROTECTION
MICRODIA MMCplus
TM
Memory Card comes pre-formatted. Make sure to back up all the data on your
MMCplus
TM
card before formatting.
Do not remove the MMCplus
TM
card and switch off any equipment using the card when data is being read,
written and transferred. It can cause data to be destroyed.
Insert the MMCplus
TM
card firmly in the correct orientation. The product will not operate correctly if it is
inserted in an incorrect orientation or not inserted all the way
Parental Guidance is needed when a child uses the MMCplus
TM
card. Teach the child how to use and protect the
product and insure that the child follows your instructions.
  • Page 1 1

Microdia MMCplus Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI