NOTE: BLUETOOTH DONGLE DEFAULT NAME IS CSR8510 A10
YOU WILL NEED TO KNOW THIS FOR THE PC APP INSTALL!
Ignore any dongle self-install messages.
Install AA 3.6v lithium battery
by unscrewing bottom connector.
Turn Adaptor on
Screw cap clockwise for on.
Counter-clockwise for off.
LED will signal BLUE (for first minute only) when ON.
Put Bluetooth 4.0+ dongle in USB port
Download and install Anuracom app software
Go to anuraco.com/registration to download for PC
IMPORTANT !!!! YOU MUST CHOOSE THE BLUETOOTH DONGLE DEFAULT FROM
THE DROPDOWN (NAME: CSR8510 A10) DURING PC APP INSTALL !!!!
Wire BLE-485 Adaptor to Sensor with RS485 M12
connector
Open Anuracom app
Click the adaptor name to connect to it and to access settings + sensor data.
To view and download data, open Aqua4Plus or
sensor software and manage sensor data live
through COM port connection (see manual for full
instructions)
1
2
3
ON OFF
4
5
6
7
NOTE:
LED will signal GREEN when Adaptor is communicating.
LED will signal RED if low on battery.
Please read all instructions before starting.
Installation for PC Windows 7,10 app version only
+
-
M12
Connector
Top cap
Circuitboard
3.6V Li
BOTTOM
TOP
Insert lithium battery