2. Rigid Industries
  3. 40281 RIGID

Rigid Industries 40281 RIGID Installation guide

  • I've examined the provided instructions for the Security Nut Kit. This document details how to install the kit using spanner nuts, washers and hex nut bolts. I'm ready to help you with any questions you may have about the product and installation process.
  • What should I do with the Nylock nut?
    What to do if Delrin Bushing came off the light?
    How many washers should be used when installing?
    What should I use to tighten the Spanner Nut?
    How often should I check the tightness?
CONTENTS
(2) 1/4” 20 SPANNER NUT
(4) 1/4” WASHERS
(1) 1/4" HEX NUT BOLT
To Install – Remove Nylock nut and discard (remember to re-install the Delrin
Bushing if it came o the light). Re-install light into aftermarket tabs, cradle, or
adjustable clamps. Depending on thickness of tab or clamp, use 1 or 2 washers
on each end. Start the Spanner Nut and tighten down with spanner bit.
Be sure to re-check tightness periodically
IS-40281 Rev2
®
Security Nut Kit
1-855-760-LEDS (5337)
Rigid Industries and Rigid are registered and/or unregistered trademarks of JST Performance, Inc. d/b/a Rigid Industries.
Rigid Industries and Rigid are registered and/or unregistered trademarks of JST Performance, Inc. d/b/a Rigid Industries.
®
FOR MORE INFO
WWW.RIGIDINDUSTRIES.COM 855.760.5337
Rigid Industries® hereby renounces any and all warranties,
guarantees, obligations, liabilities, express or implied,
arising by law or otherwise, with respect to this security kit,
and specically disclaims any implied warranty of tness for
any purpose.
/