Instruction Manual
Outdoor TV Antenna - BA-7RF
Read this manual thoroughly before you start using the Outdoor TV Antenna.
Store this manual, the completed warranty card, your receipt and the product
packaging.
The safety precautions instructions reduces the risk of fire, electric shock and
injury when correctly complied to.
Please follow all instructions and take notice of all warnings.
GENERAL SAFETY
• Do not open the product housing. There are no user-servicable parts inside.
• Do not attempt to repair unit yourself.
• Supervision is a must to ensure children do not play with this product.
• Do not expose this product to open flames or other heat sources.
• Do not drop the device.
• Keep away from magnets.
• Unplug during lightning storms or unused long periods of time.
ANTENNA BASICS
A certain amount of other interferences can aect reception. These include
obstacles and walls between the transmitter and your antenna, energy from
electronic components and building materials such as concrete or aluminium
panelling. Take into account these factors during installation. For best results,
test the antenna in dierent locations until you find a area that provides the best
reception.
COVERAGE
Check the reception in your area by visiting http://myswitch.digitalready.gov.au/
and enter your address. This antenna is suitable for areas with Good Coverage. If
your area does not have Good Coverage, you may not be able to pick up all digital
channels with this antenna.
ANGLE
Point the front or back of the Outdoor TV Antenna to face the strongest
transmission tower. (Displayed on http://myswitch.digitalready.gov.au/)
INSTRUCTIONS
AMPLIFICATION
Adjust the amplification until you receive a strong signal. To increase amplification
turn the antenna in another direction. Some areas wont require you to do this. Try
different angles, locations until you receive the strongest signal for all channels.
CONNECTING
1. Mounting Bracket installation.
Attach the mounting bracket to the antenna using the two screws and tighten
firmly.
INSTRUCTIONS (CONT.)
2. Antenna Installation.
Loosen the wing nuts, put the mast between mounting bracket, then tighting
the wing nuts.
INSTRUCTIONS (CONT.)
3. Power Supply Insert
Please refer to below image and follow instructions:
The Signal Adaptor provided (1) connects the DC Power supply (2) and the
Antenna signal cable (3) together.
(1) - Connect Adaptor into back of TV Antenna (RF) port.
(2) - Connect the DC Power Cable (2) into the DC Input Port indicated on
on the Adaptor (1).
(3) Connect the Antenna Cable from your Outdoor TV Antenna into the
Signal Adaptor (1) ANT port.
1
2
3
TIPS AND TROUBLESHOOTING
• Move the antenna around to find the best place for a strong signal.
• Never mount antenna until you have tested the antenna in the location.
• Some locations are not suitable for antennas.
SPECIFICATIONS
Frequency: VHF - (174-230MHz) / UHF - (470-862MHz)
Input Voltage DC 12V 200mA
Operating Power: 2.4W
CUSTOMER HELPLINE:
info@ayonz.com
DISTRIBUTED BY:
Ayonz Pty Ltd
/
