Lightolier PPH User manual

Category
Projector lamps
Type
User manual

This manual is also suitable for

Lightolier
45 INDUSTRIAL WAY, WILMINGTON, MA 01887
PARAPLUS (PPH), COFFAIRE (CFH) AND MINI-BEAM (MBS) INSTALLATION INSTRUCTIONS
1
© Lightolier 2004 59-31115-001 Printed in U.S.A.
IMPORTANT: For Paraplus remove Louver
before installing fixture into ceiling system.
To remove Louver, shift Louver to begin open-
ing for removal. Depress Louver as shown and
pull Louver towards you to clear Hinge Pin.
Rotate Louver up and remove.
To replace Louver (when installation is com-
plete) reverse the procedure.
For Coffaire (CFH) and Mini-Beam (MBS)
Lamp Shield does not have to be removed
before installing fixture into ceiling system.
See step 3.
To remove Access Plate, remove Screw and
slide Access Place in the direction of arrow 1.
Bend Housing Tab up to attach ground screw to
green screw on Housing Tab. Then bend
2
Housing
Hinge
Hinge
Pin
Louver
Hinge
Hinge
Pin
Housing
Louver
Housing
Hinge
Pin
Louver
Housing
Access
Plate
Screw
Housing
Housing Tab
2
1
Housing Tab down into Housing as shown.
Install Access Plate by sliding Access Plate in
the direction of arrow 2. Secure with Screw.
4
Secure fixture to Ceiling System
using Earthquake Clips (4 places)
with Screw (by others).
Install fixture into Ceiling System (by others).
For Coffaire (CFH) and Mini-Beam (MBS),
open Lamp Shield by gripping Narrow Flange
of Lamp Shield and pull Lamp Shield towards
you, letting opposite side of Lamp Shield rest
on Hinge Pins (Wide Flange).
Ceiling System
(by others)
Ceiling System
(by others)
3
Coffaire
Mini-Beam
COFFAIRE (CFH)
MINI-BEAM (MBS)
Paraplus
PARAPLUS (PPH)
Hinge Pin
(Wide Flange)
Hinge Pin
(Narrow Flange)
Lamp Shield
Screw
(By Others)
Screw
(By Others)
Earthquake
Clip
Earthquake
Clip
Exposed
Slot T-Grid
Ceiling
(By Others)
Exposed
T-Grid
Ceiling
(By Others)
Acoustical
Material
(By Others)
Acoustical
Material
(By Others)
Housing
Housing
Housing
End
Housing
End
Screw
(By
Others)
Screw
(By Others)
Ceiling Tee
(By Others)
Ceiling Tee
(By Others)
Earthquake
Clip
Earthquake
Clip
5
Ballast compartment is accessed by
removing ceiling tile adjacent to
Mini-Beam. Remove Screws at
each end of Ballast Cover. Lift
Ballast Cover for easy access to
Ballast. To replace Ballast Cover,
reverse procedure.
Ballast Cover
Ballast
Ballast Cover
Ballast
Screw
  • Page 1 1
  • Page 2 2

Lightolier PPH User manual

Category
Projector lamps
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI