TEAC LEV40A317FHD Quick start guide

TEAC
Brand
TEAC
Model
LEV40A317FHD
Type
Quick start guide
MODEL: LEV40A317FHD
Note: Please make sure that the unit is completely disconnected
from the main power supply before changing cable connections.
2.Insert batteries
according to +/- polarity
symbols.
USB
cable TV
company
VHF/UHF
antenna
Coaxial
cable
Composite
cable
Component
cable
cable receiver/satellite box
HDMI
cable
Headphones
Audio
cable
VGA
cable
RF Coaxial
cable
USBCOAXIAL
RF
Pb
PrY
HDMI1HDMI2
HDMI3
L R
AV
VGAPC AUDI O
Auto Tuning
auto tuning (ATV and DTV signals).
(For more details see "Channel Customisation", page 14 in the User Manual.)
Press key to select Channel option, and then press OK button to enter, then press
OK
key to select Auto Tuning .
"DTV", "ATV", "AV", "YPbPr", "HDMI1", "HDMI2", "HDMI3",
"PC", "USB", "DVD".
CH
+/-
+/-
+/-
+
-
15
1. Connect a USB/Hard Disk Drive (HDD) at the rear panel as shown by the picture
as below.
2. After USB/HDD is connected, you will need to format it before doing any recording.
3. Follow instructions below to enter PVR menu to format USB :
Press the MENU button on the remote control.
Select Setup tab and press enter.
Scroll down and select PVR Settings
Recording
TuningotuAVTnohctiwS
USB Media Playback
WARNING: Formatting an external drive will erase all memory in the system. Please make sure
that no important documents are stored in the external drive before formatting. TEAC is not
responsible for any loss of data.
TEAC WARRANTY SERVICE HOTLINE
L-in R-inVideo
USB
A Connect your antenna to the RF port. Connect the power plug to the TV.
Plug your TV (and any other connected devices) into the wall power outlet. Switch on the wall outlet's power.
B
C
The TV should now be in Standby Mode with the LED indicator lighted up in red. Press the POWER button
on the TV or remote control to turn it on. The LED light will switch to blue when the TV is on.
4. Press the button to stop recording.
A Connect a USB/Hard Disk Drive (HDD) at the rear panel of the unit.
B Press INPUT button to set the Source to Media.
C Press ▲/▼ button to select MEDIA in the Source Menu, and then press OK or ► to enter.
D Press button to select the option that you want to adjust in the Media menu, then press
OK button to enter.
(For more details, refer to "Media Operation", page 18-21 in the User Manual.)
Monday - Friday, AEST 8.30AM - 5PM
NOTE: For best performance with
external HDDs, use a HDD with an
external power supply.
1300 553 315
HDMIHDMIHDMI
Y Pb Pr
L-in R-inVideo
USB
COAXIAL
1 / 7
  • Page 1 1
  • Page 2 2

TEAC LEV40A317FHD Quick start guide

TEAC
Brand
TEAC
Model
LEV40A317FHD
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents