V-ZUG MWC-XSL/60-c Chrome Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
This manual is also suitable for
Installation instructions
Microwave
Type of construction 60-450
J939.113-0
4000 103 57476
17.12.10 GOE
1
These installation instructions apply to the model: 939
Identification plate
➤ Open appliance door. The identification plate is located at the front on the bottom left-hand
side (see illustration).
➤ Refer to the identification plate for specifications for the required mains voltage, current type and fuses.
➤ Application height of the appliance: up to max. 2000 m above sea level
➤ The appliance is equipped with a mains cable that should be connected to a distribution box by the customer. For pyrometric reasons
the connection cable is not to be exchanged.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be
strictly observed.
Electrical connections
Electrical connections must made by trained electricians in accordance with the guidelines and standards for low voltage
installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An
all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and
socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching
are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and
fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should
always be checked.
230 V~
PE/ green/yellow
N blue
L1 brown
4000-103-57476
Installation instructions
Microwave
Type of construction 60-450
J939.113-0
4000 103 57476
17.12.10 GOE
2
Installing
1. Screw the mounting rail to the floor with the 2 supplied screws A.
2. Place appliance in front of the niche and insert the mains plug.
3. Carefully slide appliance into the niche until it is flush with the front of the cabinets, ensuring that the mains cable is not pinched.
4. Open the appliance door and from the front secure the appliance at the sides with the 2 supplied screws S.
Installing with a second appliance in the same niche
1. Screw the mounting rail to the floor with the 2 supplied screws A or to the bracket with screws B.
2. Place appliance in front of the niche and insert the mains plug.
3. Carefully slide appliance into the niche until it is flush with the front of the cabinets, ensuring that the mains cable is not pinched.
4. Open the appliance door and from the front secure the appliance at the sides with the 2 supplied screws S.
Installation
This appliance is only intended for the installation in a niche.
If a second appliance is installed in the same niche (above or below the appliance), you should use bracket set 60 W to support
the upper appliance.
It is not possible to install the appliance above an extractor oven because of the extraction pipes that lead upwards.
Below a second appliance Above a second appliance
350
(567)
454
596
540
~85˚
=
=
50
min. 550
600
560–568
20
~45
545
S
X
450
A
Detail X
450
Niche
454
Appliance
560–568
50
456
W
min. 550
A
560–568
450
min. 550
50
W
B
-
1
-
2
V-ZUG MWC-XSL/60-c Chrome Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
V-ZUG 953 Installation guide
-
-
-
-
V-ZUG 2300775002 Installation guide
-
V-ZUG 68A Installation guide
-
-
-
-