V-ZUG 953 Installation guide

Installation instructions

System drawer 60-76

J953.113-0

17.2.09 ITH

These installation instructions apply to the model: 953

Identification plate

A Remove the drawer. The identification plate is located on the inside of the appliance.

1. Fasten the 2 supplied angle brackets A in place. Use 2 screws to fix each bracket. The bevelled edges must be toward the back.

2. Push the appliance carefully into the niche, with the front aligned flush with the cabinet front.

3. Open the drawer and fix in place from the front, using the 4 supplied screws B.

Installing with Coffee-Center

The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order

specified.

Validity

General notes

If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strict-

ly observed.

Installation

The drawer must be secured by 4 screws and 2 angle brackets to prevent tipping.

450

596

560

326

600

min. 550

560–568

37874

450

374

Detail X

594

Niche

598

Appliance