Russell Hobbs 18510-56 User manual

Page is loading ...

66

Read the instructions and keep them safe. If you pass the appliance on, pass on the instructions

too. Remove all packaging, but keep it till you know the appliance works.

A IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:

1 This appliance must only be used by a responsible adult. Use and store the appliance out of

reach of children.

2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.

3 Unplug before dismantling or cleaning.

4 Switch oﬀ (0) before ﬁtting the jug to the motor unit.

5 Switch oﬀ (0), and wait till the blades come to a stop before removing the lid from the jug, or

removing the jug from the motor unit.

6 Don’t ﬁll with anything hotter than you can comfortably handle (i.e. liquid temperature

below 40°C).

7 Don’t put your hand into the jug, even after you’ve removed it from the motor unit

– the blades are sharp.

8 Don’t put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in.

9 Don’t leave the appliance unattended while plugged in.

10 Don’t let the jug overﬂow. If liquid gets under the motor unit, it may be sucked into the motor,

damaging it.

11 Don’t ﬁt any attachment or accessory other than those we supply.

12 Don’t use the appliance for any purpose other than those described in these instructions.

13 Don’t operate the appliance if it’s damaged or malfunctions.

14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or

someone similarly qualiﬁed, in order to avoid hazard.

household use only

C PREPARATION

1 Sit the motor unit on a dry, ﬁrm, level surface, near a power socket.

2 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.

3 Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.

4 Pull the lid up and oﬀ the jug – it’s stiﬀ, because of the seal.

5 Put the ingredients into the jug.

6 Don’t ﬁll past the 1500ml mark. If you do, the contents may force the lid oﬀ when you start

the motor.

C FIT THE LID

7 Put the lid on the jug, and press it down.

8 Align the pips on the cap with the slots in the hole, ﬁt the cap, and turn it clockwise to lock it.

9 Don’t run the appliance without ﬁtting the cap.

C SWITCH ON

10 Check that the speed control is set to 0.

11 Put the plug into the power socket.

C SPEED CONTROL

12 Turn the speed control to the speed you want (1 = low, 2 = high).

13 Turn the speed control back to 0 to turn the motor oﬀ.

14 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer

timings and slower speeds.

15 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and

higher speeds.

67

16 Don’t run the motor continuously for more than 2 minutes, it may overheat. After 2 minutes

switch oﬀ for at least 2 minutes, to recover.

Y PULSE

17 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In

this direction, the knob is spring-loaded. When you let go, it’ll return to 0.

C ADDING INGREDIENTS

18 To add ingredients while the blender is working, remove the cap, pour the new ingredients

through the hole, then replace the cap.

19 Check that the added ingredients don’t push the volume in the jug past the 1500ml mark.

C FINISHED?

20 Switch oﬀ (0), and wait till the blades come to a stop before removing the lid from the jug, or

removing the jug from the motor unit.

21 Turn the jug anti-clockwise, and lift it oﬀ the motor unit.

Y CRUSHED ICE

22 Start with half to threequarters of a cup of ice, or 4 to 6 cubes, and add 15ml (1 tablespoon) of

fresh cold water.

23 Put the lid on the blender, then turn the speed control to Y for a second or two, and release

it.

24 Check the results, and adjust.

C CARE AND MAINTENANCE

25 Switch the appliance oﬀ (0) and unplug it.

26 Turn the jug anti-clockwise, and lift it oﬀ the motor unit.

27 Wash the jug, lid and cap in warm soapy water, rinse well, then leave the jug to drain and air

dry.

28 Wipe the outside of the motor unit with a clean damp cloth.

29 Don’t put any part of the appliance in a dishwasher.

F BLADE UNIT

30 You may remove the blade unit for cleaning.

31 Grip the jug handle with one hand.

32 Grip the jug base with the other hand.

33 Unscrew the jug from the jug base.

34 Carefully, lift the blade unit out of the jug base.

35 Llift the seal away from the blade unit.

36 Wash the seal and blade unit in warm soapy water, rinse, and air dry.

37 Replace the seal round the blade unit.

38 Replace the blade unit in the jug base.

39 Screw the jug into the jug base.

instructions

diagrams

0 oﬀ

1 low

2 high

3 speed control

4 motor unit

Y pulse

5 jug base

6 blade unit

7 seal

8 jug

9 lid

10 hole

11 slots

12 pips

13 cap

68

H ENVIRONMENTAL PROTECTION

To avoid environmental and health problems due to hazardous substances in electrical

and electronic goods, appliances marked with this symbol mustn’t be disposed of with

unsorted municipal waste, but recovered, reused, or recycled.

recipes

h = handful

c = clove(s)

coriander pesto

2 h coriander leaves

2 c garlic

60 g pine nuts

125 m olive oil

60 g Parmesan, grated

Process the coriander, garlic, pine nuts and half the oil till smooth. Transfer to a large bowl.

Stir in the Parmesan. Add oil to adjust the consistency: For a dip: thick. For a topping: medium.

For pasta sauce: thin.

recipes are available on our website:

http://www.russellhobbs.com/ifu/550931

smoothies:

http://www.russellhobbs.com/ifu/550941

551-122

Russell Hobbs 18510-56 User manual

Related papers

Other documents