Russell Hobbs 19450-56 User manual

Page is loading ...

66

Read the instructions, keep them safe, pass them on if you pass the appliance on.

Remove all packaging before use.

A IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:

1 This appliance must only be used by or under the supervision of a responsible adult. Use and

store the appliance out of reach of children.

2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.

3 Unplug before dismantling or cleaning.

4 Switch oﬀ (0) before ﬁtting the jug to the motor unit.

5 Switch oﬀ (0), and wait till the blades come to a stop before removing the lid from the jug, or

removing the jug from the motor unit.

6 Don’t ﬁll with anything hotter than you can comfortably handle (i.e. liquid temperature

below 40°C).

7 Don’t put your hand into the jug, even after you’ve removed it from the motor unit – the

blades are sharp.

8 Don’t put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in.

9 Don’t leave the appliance unattended while plugged in.

10 Don’t let the jug overﬂow. If liquid gets under the motor unit, it may be sucked into the motor,

damaging it.

11 Don’t use accessories or attachments other than those we supply.

12 Don’t use the appliance for any purpose other than those described in these instructions.

13 Don’t operate the appliance if it’s damaged or malfunctions.

14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or

someone similarly qualiﬁed, in order to avoid hazard.

household use only

C PREPARATION

1 Sit the motor unit on a dry, ﬁrm, level surface, near a power socket.

2 Hold the jug above the motor unit, with the handle between the speed control and the u

arrow on the motor unit.

3 Lower the jug on to the motor unit, then turn the jug to align the handle with the u arrow

on the motor unit.

4 Turn the lid clockwise to unlock it (U), then lift it oﬀ the jug.

5 Put the ingredients into the jug.

6 Don’t ﬁll past the 1500ml mark. If you do, the contents may force the lid oﬀ when you start

the motor.

C FIT THE LID

7 Fit the lid, with the tab in front of the handle.

8 Turn the lid anti-clockwise (L) till the latch clicks into the safety interlock.

9 Push the cap into the hole in the lid.

10 Don’t run the appliance without ﬁtting the cap.

C SWITCH ON

11 Check that the speed control is set to 0.

12 Put the plug into the power socket.

C SPEED CONTROL

13 Turn the speed control to the speed you want (1 = low, 2 = high).

14 Turn the speed control back to 0 to turn the motor oﬀ.

67

15 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer

timings and slower speeds.

16 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and

higher speeds.

17 Don’t run the motor for more than 1 minute, or it may overheat. After 1 minute, switch oﬀ for

at least 2 minutes, to let the motor cool.

Y PULSE

18 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In

this direction, the knob is spring-loaded. When you let go, it’ll return to 0.

C ADDING INGREDIENTS

19 To add ingredients while the blender is working, remove the cap, pour the new ingredients

through the hole, then replace the cap.

20 Check that the added ingredients don’t push the volume in the jug past the 1500ml mark.

C FINISHED?

21 Switch oﬀ (0), and wait till the blades come to a stop before removing the lid from the jug, or

removing the jug from the motor unit.

C CARE AND MAINTENANCE

22 Switch the appliance oﬀ () and unplug it.

23 Wipe the outside of the motor unit with a clean damp cloth.

24 Wash the removable parts in warm soapy water, rinse well, drain, and air dry.

25 Don’t put any part of the appliance in a dishwasher.

F BLADE UNIT

26 You may remove the blade unit for cleaning.

27 This is best done with the jug turned upside down.

28 Grip the jug handle with one hand.

29 Grip the bottom of the blade unit with the other hand.

30 Turn the blade unit anti-clockwise till it comes loose from the jug base.

31 Carefully, pull it up and out of the bottom of the jug.

32 Lift the seal away from the blade unit.

33 Wash the seal and blade unit in warm soapy water, rinse, and air dry.

34 Take great care with the blades – don’t handle them directly, use a nylon washing-up brush.

35 Replace the seal round the blade unit.

36 Replace the blade unit in the jug base.

37 Turn the blade unit clockwise to tighten it.

H ENVIRONMENTAL PROTECTION

To avoid environmental and health problems due to hazardous substances in electrical

and electronic goods, appliances marked with this symbol mustn’t be disposed of with

unsorted municipal waste, but recovered, reused, or recycled.

instructions

diagrams

0 oﬀ

1 low

2 high

3 speed control

4 motor unit

Y pulse

5 blade unit

6 seal

7 jug

8 safety interlock

9 latch

10 tab

11 lid

12 cap

68

recipes

h = handful

c = clove(s)

coriander pesto

2 h coriander leaves

2 c garlic

60 g pine nuts

125 m olive oil

60 g Parmesan, grated

Process the coriander, garlic, pine nuts and half the oil till smooth. Transfer to a large bowl.

Stir in the Parmesan. Add oil to adjust the consistency: For a dip: thick. For a topping: medium.

For pasta sauce: thin.

recipes are available on our website:

http://www.russellhobbs.com/ifu/550931

Page is loading ...

Russell Hobbs 19450-56 User manual

Russell Hobbs 19450-56 User manual

in other languages

Related papers

Other documents