2. Troy-Bilt
  3. 24CF572B711
24CF572B711

Troy-Bilt 24CF572B711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 24CF572B711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Remove the hardware from the tank
bracket. Align holes of tongue with holes
in tank bracket and secure with the
hardware just removed.
Tools Required:
• /-inch wrench (or adjustable wrench)
• /-inch wrench (or adjustable wrench)
778 -13018© 2012 24CF572B
A. Release the
beam lock.
A. Remove the spring
clip and clevis pin.
B. Pivot jack stand into
operating position.
C. Secure the jack
stand with the
spring clip and
clevis pin.
Lift and slide
the cylinder
to the top of the beam
and onto the bracket.
A. Remove the dislodger.
B. Remove the log tray and two adjacent screws
from the left side of the beam.
A. Re-attach the dislodger.
B. Re-attach the log tray.
BA
Jack Stand
Cylinder
Tongue
Dislodger
Control
Handle
Wedge
Beam
Log Tray
A
IMPORTANT: Carefully follow all uncrating steps.
Refer to Operator’s Manual for instructions.
B
1
2
B. Pivot the beam
downward into the
horizontal position
and lock.
B
A
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help? Call 1-888-TO-HELP-U
778 -13018© 2012 24CF572B
Rotate the Engine Stop Switch
to the ON position.
Fill tank with gas to bottom of fuel level limit in
the neck of the fuel tank. Do not overfill. Turn fuel
valve to ON position.
Grasp the Starter Rope Handle and pull with a quick, full
arm stroke.
If engine does not start after ten seconds of repeated
pulls, wait a few minutes and repeat.
Push the Choke Control inward after engine starts.
IMPORTANT: Check engine oil, lubricate beam,
check hydraulic fluid level and prime the pump before operating.
Refer to Operator’s Manual for instructions.
Starter Rope
Handle
Gas Cap
Choke Rod
Engine Stop
Switch
Fuel Valve
Remove the bow-tie clip and clevis pin from
the control handle.
B
C
A
A. Pivot the control handle upward
B. Reinsert the
clevis pin.
C. Secure the control handle
with the bow-tie clip.
OFF
ON
Pull the Choke Rod outward.
7
10
8
11
9
12
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help? Call 1-888-TO-HELP-U
/