Promate SolarLamp-2 User guide

Category
Power banks
Type
User guide
English
Introduction
The best choice for ambient lighting when outdoors. SolarLamp-2 is battery-operated and has a
solar charger that lets you charge the light efficiently when outdoors. This makes SolarLamp-2 the
most versatile utility light in the range, especially with its sleek structure.
Packaging Contents
• SolarLamp-2
Solar Panel
Mobile Phone Charging Cable
User Guide
Specifications
Battery Capacity: 2600mAh * 2
Battery Type: Li-ion
Solar Panel Input: 3W/6V
LED Brightness: 200lm
Charging Time: 10 Hours
Usage Time: 4-19 Hours
English
2
Features
Long Solar Panel Lifespan: Anti-reflective, low iron-tempered solar panel with
enhanced stiffness and impact resistance
Super Bright: 200lm LED offers super bright lighting for a wide area and strong
illumination.
Long Working Time & Energy Saving: SolarLamp-2 takes 10 hours to charge and the
light lasts all night on a full charge.
Easy to Install: Super easy to setup and install, add the needed light source without
the added expense and trouble of installing electrical wire. You can install it in any
place that has direct sunshine.
Precautions
Please read all safety instructions and warnings thoroughly before using this product.
Improper use of this product may result in damage to this or attached products.
1. Do not disassemble the product or attempt to fix it.
2. Kindly use an original charging cable provided to charge the product.
3. Do not crush, puncture, dispose of in fire, short the contacts or expose the product
to water or other liquids.
4. Do not store or use the product in a high-temperature environment, including
intense sunlight or heat.
5. Avoid drops, bumps, abrasions and impacts.
6. If there is any reason to believe that there is damage to the product, discontinue
use immediately.
7. If you find that the product is too hot, is emitting an odour, or is deformed,
punctured or exhibits any suspicious or abnormal behaviour, discontinue use
immediately and contact our customer service.
English
3
Appearance & Interface Description
1. USB Port
2. On/Off Switch
3. Indicator Light
Operation Instructions
Please fully charge the SolarLamp-2 before first time use. When charging,
the indicator will be red. Once fully charged, the light will turn green in
color.
Important: Make sure you turn off the SolarLamp-2 before charging the
battery.
A) LED Lighting
1. Turn SolarLamp-2 on and select the desired brightness (3 levels: Bright,
Brighter, Brightest).
2. Keep in mind the working time for each selected brightness level.
3. AC 110V-220V (Not included).
B) Cellphone Charging
Connect the bundled USB 5-in-1 mobile phone charger to the USB port on
the SolarLamp-2 to charge your USB-powered mobile devices.
Note: In order to protect and save the battery, a maximum of two mobile
phones should be charged at the same time with the bundled 5-in-1 USB
cable.
1
2
3
SolarLamp-2
SolarLamp-2
Battery Capacity: 2600mAh
Battery Type: Li-ion
Solar Panel Input: 3W/6V
LED Brightness: 200 lumens
S/N:
Made in China
www.promate.net
180202
English
4
Battery Charging
1.By Solar Panel
Plug the solar panel's 2-in-1 cable into the 2 lamps and expose the solar panel
to direct sunlight
For best performance
Always keep the surface clean and avoid scratching it
Always place the solar panel in an area that gets as much sunlight as
possible
Store the solar panel indoors when not in use; it will prevent damage due to
bad weather
Keep the lamp shaded from the sun during charging to protect it well
Battery care & Maintenance
The SolarLamp-2 uses a 3.7 volt, 2600mAh Lithium rechargeable battery.
To keep your battery working perfect
Immediately charge the battery after complete discharge
Never leave the battery in a fully discharged state
Recharge the battery even if fully charged at least once every two months
Attention:
Do not use this battery for other products
When replacing the battery, ONLY USE a 3.7volt Lithium rechargeable
battery for replacement
English
5
Correct disposal of this Product
(Waste Electrical & Electronic Equipment (WEEE)
Your product is designed and manufactured with high quality materials and components
which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end of-life should be
disposed of separately from your household waste.
Please dispose of this equipment at your local community waste
collection/recycling center.
This product complies with European safety and electrical interference directives
This product does not contain environmentally hazardous materials (lead, mercury,
cadmium, hexavalent chromium and brominated flammable agents: PBB and PBDE).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28

Promate SolarLamp-2 User guide

Category
Power banks
Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI