Ortech 3109-3CCT User manual

Brand: Ortech

Model: 3109-3CCT

Type: User manual

This manual is also suitable for

Ortech 3109-3CCT is a LED Flush Mount suitable for damp locations. It is designed for use in a circuit protected by a fuse or circuit breaker. It is recommended to have it installed by a qualified electrician in accordance with local electrical codes. The fixture is designed to be surface mounted and should not be covered with any heat insulated materials. It operates within a temperature range of -20 to +40 degrees Celsius and uses a 120V AC 50/60Hz circuit. Please refer to the installation manual for more detailed instructions and safety precautions.

WARNING

LED Flush Mounts

MODEL 3109-3CCT / 3112-3CCT / 3116-3CCT

1.WARNING: Risk of fire.

2.Before installing your lighting fixture, thoroughly review enclosed installation manual. If you do not have sufficient electrical wiring experience, please refer

to a do-it-yourself wiring handbook or have your fixture installed by a qualified licensed electrician. All electrical connections must be in a accordance with

local standards. Reliable operating temperature is -20 to +40 degrees.

3.Please obey fire prevention regulations, do not cover the fixture with any heat insulated materials.

4.Do not change the LED light source or driver inside under any circumstance.

INSTALLATION GUIDE

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

1. LED Flush Mounts are suitable for using in damp locations

2. Please keep the LED Flush Mounts away from any corrosive substance, and please use

dry cloth when you clean it

3. LED Flush Mounts can only be installed by a qualified electrician

4. Before installation or maintenance, please disconnect the power to prevent electric shock

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.ca

205 Summerlea Rd

Brampton, ON L6T 4E5

CAUTION

Application Notice

1. Turn OFF the power supply at the fuse or circuit breaker box before you install the fixture

2. Ground the fixture to avoid potential electric shocks and to ensure reliable starting

3. Double-check all connections to be sure they are tight and correct

4. Wear rubber soled shoes and work on a sturdy wooden ladder

5. This fixture is designed for use in a circuit protected by a fuse or circuit breaker. The fixture is also designed to be installed in accordance with local

electrical codes. If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code

6. WARNING — RISK OF CUTS: Some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts

7. WARNING — RISK OF FIRE: Use 120V AC 50/60Hz circuits

8. DO NOT change the LED light source or driver inside under any circumstance

9. DO NOT cover the fixture with any heat insulated materials

Surface Mounting Installation

ORTECH reserves the right to modify at any time, without notice, any or all of our product's

features, designs, components and specifications to meet market changes.