Shenzhenshimasidakejiyouxiangongsi PC-QI-3W Operating instructions

instructions

usage method

1. Insert the GB small module of ivygrow into the weight card slot on the bottom of

the mouse, and the magnetic suction is aligned automatically. After installation in

place, place the mouse on the supporting wireless charging board to realize

wireless charging. (to be aligned with the charging area)

2. During wireless charging, you can check the charging status on the mouse driver

page (please make sure the driver is updated to 2022.3.24300 and above)

matters needing attention

1. In order to avoid situations such as high temperature, charging interruption, or lack

of recognition caused by the mismatch of wireless chargers, please use the

officially designated wireless charging board.

2. The mouse itself has a battery protection mechanism. When it is charged to more

than 80%, the displayed power remains unchanged (the maximum power

percentage displayed by each model of mouse is different, which is related to the

mouse firmware). There are problems with non rechargeable devices.

3. During charging, when the power of the mouse is more than 80%, please stop

using the wireless charger in time to avoid damaging the equipment due to high

temperature caused by overcharge for a long time.

4. This product has been tested in detail before leaving the factory. If the charging is

abnormal, there may be the following reasons:

4.1. The power plug of the wireless charger does not meet the requirements;

4.2. Not using the officially designated wireless charger;

4.3. Abnormal display of mouse and computer driver;

4.4. The magnet on the bottom of the mouse is dirty;

4.5. The mouse and wireless charger failed to align with the charging position;