Atdec AWM-FH Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Atdec AWM-FH Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
AWM-FH Page 1 of 2
Installation Guide
AWM-FH
Heavy Duty F Clamp
COMPONENT CHECKLIST
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! This product is compatible with Atdec AWM Series products.
! The manufacturer accepts no responsibility for incorrect installation.
D
5mm
Allen key
(x1)
B
Lower Clamp
(x1)
A
Upper Clamp
(x1)
C
Screw
M8 x 16mm
(x2)
REQUIRED TOOLS
• All tools provided
AWM-FH Page 2 of 2
1. Attach post or base to upper clamp
1.1 Option A - Attach post to upper clamp 1.2 Option B - Attach base to upper clamp
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20180530D
2. Attach lower clamp to upper clamp
3. Fit fixing to work surface
Fasteners
supplied
with post
Note: post sold separately Note: base sold separately
Fasteners
supplied
with base
3.1 Place in desired location on worksurface 3.2 Screw in both pressure plates and
tighten evenly and firmly
2.2 Attach lower clamp to upper clamp in the
suitable position using the two provided screws.
2.1 Measure the worksurface thickness and
choose the suitable lower clamp position
Note: If there is only a small gap behind the
worksurface, perform Step 3.1 before this step.
Post Installation Base Installation
Mounting
surface
5mm
allen key
T M B
Top
Middle
Bottom
0 - 38mm (0.00 - 1 ½”)
11 - 53mm ( - 2 )
25 - 68mm (1” - 2 ”)
/