2. Schlage
  3. LRP Lock Replacement Plates

Schlage LRP Lock Replacement Plates Installation guide

  • Hello! I've reviewed the Locknetics LRP Lock Replacement Plates installation instructions. This document provides a clear guide on how to properly install LRP lock replacement plates, including securing the plates to escutcheons, applying gaskets and caulk for exterior doors, and assembling them to inside baseplates. Feel free to ask me any questions about the instructions or features described in the document.
  • What is the required door thickness adjustment for locks used with the LRP kit?
    How is the LRP secured to the outside escutcheon?
    What should be done when installing the LRP on an exterior door?
LRP Lock Replacement Plates
INSTALLATION INSTRUCTIONS
575 Birch Street, Forestville, CT 06010
Phone (860) 584-9158 Fax (860) 584-2136
www.locknetics.com
FORM 56000 103/27/2001
Old CM Lock prep
1. Feed wire harness through appropriate
hole as shown. Secure LRP to outside
escutcheon using two #10-24x1/4”
screws. If the lock is on an exterior door,
be sure to apply the exterior gasket
between the LRP and the outside
escutcheon and apply a bead of caulk as
shown. Do not caulk along the bottom.
2. Assemble the other LRP to the
inside baseplate using one
#8-32x1/4” screw as shown. Leave
the screw loose enough to pivot the
LRP about.
3. Install assemblies to door using
standard instructions. When installing
the inside base plate swing the LRP
outward so wire harness can fit
through hole - then swing it back to
line up with edges and tighten the
#8-32 screw. Complete the installation
using the standard instructions.
Caulk here for exterior
applications.
IMPORTANT! Locks used with the LRP kit must have been ordered
with door thickness kit 1/4” larger than actual door thickness.
/