Soundcore Life P2 User manual

Type
User manual

This manual is also suitable for

USER MANUAL
Soundcore Life P2
English 01 Português 66
Čeština 06 P
усский
71
Dansk 11 Slovenský Jazyk 76
Deutsch 17 Slovenski Jezik 81

21 Svenska 86
Español 26 Türkçe 91
Suomi 31
日本語
96
Français 36
한국어
101
Magyar 41
简体中文
106
Italiano 10
繁體中文
111
Nederlands 51 Portugues do Brasil 116
Norsk 56


121
Język polski 61


126
01 EN
EN 02
Charging
Remove the protective lm from the earbuds when using for the rst time.
Fully charge both the earbuds and the charging case before the rst-time using.
To prevent damage, use the provided USB-C cable.
Fully dry off the earbuds and the USB port before charging.
1
RR
2
LED behaviour (Earbuds & Charging case)
Steady white Being Charging
Light off
Fully charged
Remaining battery >10% (when in use)
Powering On/Off
The earbuds will automatically power on when taken out of the charging case and power off
when placed back into the charging case.
ON
OFF
LED behaviour (Earbuds)
ON Steady white for 1 second
OFF Steady red for 1 second
To manually power on, press the multi-function button on either one of the earbuds.
To manually power off, press and hold the multi-function button on either one of the
earbuds for 3 seconds.
Pairing
True Wireless Stereo Connection
The right earbud will automatically connect with the left earbud when taken out of the
charging case.
LED behaviour (Earbuds)
Breathing white TWS connecting
Steady white for 1 second TWS connected
When powered off, press and hold the multi-function button on both earbuds for 1
second, the earbuds will enter TWS connecting mode.
When powered on and connected, place either one of the earbuds into the charging case,
you can keep using the other one.
When powered on and connected, if either one of the earbuds is out of battery and
powered off, you can keep using the other one.
When you are on a call, place either one of the earbuds into the charging case, 3 to 5
seconds later, the microphone in the other earbud will be activated.
Bluetooth Pairing with your Device
The earbuds will enter pairing mode when powered on. You are requested to confirm the
connection when you see a pop-out screen.
03 EN
EN 04
Soundcore
Life P2
Bluetooth Pairing Request
“Headset” would like
to pair with your iPhone
Cancel Pair
Pair
LED behaviour (Earbuds)
Flashing white Bluetooth pairing
Steady white for 1 second Bluetooth connected
In the pairing process, some devices are incompatible with Qualcomm True Wireless Primary-
Secondary dual pairing names, it may notice “connection unsuccessful” when you tap “Pair”
or even no screen popped out. Don’t worry and it will not inuence the using.
Once successfully paired, the primary earbud connects with your device and transfers signal
to the secondary earbud, the latter one will not connect with your device. As a result, in the
Bluetooth pairing list on your device, it may indicate that only one side is connected while the
other side is not.
To pair with another Bluetooth device, turn off Bluetooth on the currently connected
device rst.
Each time you power on your Soundcore earphones, it will automatically connect to your
last successfully connected device if available within the Bluetooth range.
Wearing
1. Choose the ear tips that t your ears the best.
2. Insert the earbuds into the inner canal of your ears.
3. Turn and nd the most comfortable position.
Controls
Play / Pause
1
R\L
Press (R/L)
Next track
R
2
Press twice (R)
Previous track
2
L
Press twice (L)
Volume up / down Control volume via the connected device
Answer / End a call
1
R\L
Press (R/L)
Reject a call
1”
R\L
Press and hold for 1 second (R/L)
Enable mono mode Remove either one of the earbuds off your ear and press and hold
the button on the other earbud for 1 second
Activate Siri or other voice
assistant software
1”
R\L
Voice Assistant
Press and hold for 1 second (R/L)
Reset
Reset the earbuds if the earbuds cannot connect with each other properly or cannot connect
with your device properly.
1. Place the earbuds into the charging case and make sure they are being charged.
2. Press and hold the button on both earbuds for 3 seconds until the LED indicators ash red 3
times and then turn white.
All the memory data will be cleared.
CS 06
05 EN
3”
L
R
3
Specifications
Specications are subject to change without notice.
Input 5 V 500 mA
Rated output power 7 mW @ 1% THD
Battery capacity 55 mA x 2 (earbuds); 700 mA (charging case)
Charging time 2 hours
Playtime (varies by volume level and content) 7 hours (Totally 40 hours with the charging case)
Driver size 6 mm × 2
Frequency response 20 Hz - 20 kHz
Impedance 16 Ω
Bluetooth version V 5.0
Bluetooth frequency 2402-2480 MHz
Audio codec format SBC, AAC, aptX
Bluetooth range 10 m / 33 ft
Qualcomm® aptX
TM
Technical specications
Compression ratio: 4:1
Word depth: Support 16bit and 24bit
Decoding delay: Sample rate 48kHz<2ms
Dynamic range: 16bit>92dB, 24bit>120dB
Data rates: 352kbps
Decode mode: Stereo
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and
other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., registered
in the United States and other countries.
Nabíjení
Před prvním použitím odstraňte ze sluchátek ochrannou fólii.
Před prvním použitím sluchátka i nabíjecí pouzdro úplně dobijte.
Používejte dodávaný kabel USB-C, abyste zabránili poškození.
Před nabíjením sluchátka a port USB úplně vysušte.
1
RR
2
Chování LED (sluchátka a nabíjecí pouzdro)
Svítí bíle nepřerušovaně Nabíjí se
Nesvítí
Plně nabito
Zbývající baterie > 10% (během používání)
Zapnutí/Vypnutí
Sluchátka se automaticky zapnou, když je vytáhnete z nabíjecího pouzdra, a vypnou, když je
vrátíte zpět do nabíjecího pouzdra.
ON
OFF
Chování LED (sluchátka)
ZAPNOUT Svítí bíle po dobu 1 sekund
VYPNOUT Svítí červeně po dobu 1 sekund
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66

Soundcore Life P2 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI