Page is loading ...
(E) 10/04
ASSEMB LY I NST R UCT I ONS FOR W B 1238
IMPORTANT:
TURN OFF POWER AT MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs are not included.
1. Install a hex nut onto one end of long threaded
pipe leaving about 1/2 in. (13mm) of thread
exposed. Insert a lock washer and then fasten
same end of pipe into tab, located at bottom of
fixture plate, with a hex nut from above.
2. Lay glass shade on top of fixture plate. Then
install cage onto fixture plate by fastening
with machine screws at top section. Then slip
font till it checks onto bottom of cage and lock
into position with a finial.
3. Follow enclosed “Multiple Standard
Installation Instructions” for electrical and
fixture installation onto outlet box.
4. Install light bulb (not included). See relamping
label located at socket area for type and
maximum allowed wattage.
MUR R AY FEI SS
©M UR R AY FEI SS I M PO RT LL C.
Bulb (not included)
Machine Screws
Fixture Plate
Hex Nut
Hex Nut
Socket
Lock Washer
Long Threaded Pipe
Glass Shade
Cage
Cap Nut
Font
Finial
Mounting Strap
/
