MGP WE-47-2 Installation guide

WE-42

Willow Edging Assembly

1-800-574-7248

www.mastergardenproducts.com

Unpack your Willow Edging and

it should look like the following

image:

Using the two stakes at the ends of the

item, push them into the area you decide to

put your Willow Edging. Only push your

Willow Edging into the ground if your soil is

soft and loose. If you have hard soil, we

would recommend getting a thin metal

stake, long screw driver, or any object thin

and long enough to put in, and hammer it

into the ground. This will create the two

holes you need in order to install the Wil-

low Edging.

If you are using multiple pieces of Willow

Edging, we would recommend using some

wire or a zip tie to secure the Willow Edg-

ing Stakes together. You may put the stake

next to the other Willow Edge piece into

the same hole as the other one. Always be

sure to backfill the holes together to secure

the Willow Edging. A picture description is

shown below. Zip ties and wires are not

included.

This manual is also suitable for

Download PDF