Noble House 300378 is an umbrella base designed to be used with a matching table and umbrella. It is not suitable for use as a freestanding umbrella base. The maximum diameter for an open umbrella used with this base is 86 inches.
The base comes with all the necessary hardware for assembly, including a bolt, washer, socket wrench, and 38mm & 48mm adapter. Assembly takes approximately 30 minutes and requires two people.
To assemble the base, tilt it on its side and attach the support pole to the base using the bolt and washer. Tighten the bolt until fully secure. Then, insert the 38mm & 48mm adapter into the support pole, and insert the umbrella pole into the adapter. Tighten the adjustable screws on the support pole securely in a sequential manner to the umbrella pole.
Noble House 300378 is an umbrella base designed to be used with a matching table and umbrella. It is not suitable for use as a freestanding umbrella base. The maximum diameter for an open umbrella used with this base is 86 inches.
The base comes with all the necessary hardware for assembly, including a bolt, washer, socket wrench, and 38mm & 48mm adapter. Assembly takes approximately 30 minutes and requires two people.
To assemble the base, tilt it on its side and attach the support pole to the base using the bolt and washer. Tighten the bolt until fully secure. Then, insert the 38mm & 48mm adapter into the support pole, and insert the umbrella pole into the adapter. Tighten the adjustable screws on the support pole securely in a sequential manner to the umbrella pole.
Noble House 300378 is an umbrella base designed to be used with a matching table and umbrella. It is not suitable for use as a freestanding umbrella base. The maximum diameter for an open umbrella used with this base is 86 inches.
The base comes with all the necessary hardware for assembly, including a bolt, washer, socket wrench, and 38mm & 48mm adapter. Assembly takes approximately 30 minutes and requires two people.
To assemble the base, tilt it on its side and attach the support pole to the base using the bolt and washer. Tighten the bolt until fully secure. Then, insert the 38mm & 48mm adapter into the support pole, and insert the umbrella pole into the adapter. Tighten the adjustable screws on the support pole securely in a sequential manner to the umbrella pole.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI