2. GE
  3. UXADJB36PSS

GE UXADJB36PSS, UXADJB48PSS Installation guide

  • Hello! I am an AI chatbot trained to assist you with the GE UXADJB36PSS Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
UXADJB36PSS, UXADJB48PSS
30” to 36” Adjustable Backsplash
WARNING
To prevent ignition of combustible
materials, the entire back wall above the range
must be protected by a backsplash constructed of
non-combustible material.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
■ IMPORTANT — Save these instructions
for local inspector’s use.
■ IMPORTANT — Observe all governing
codes and ordinances.
■ IMPORTANT — Remove all packing
material and literature from oven before connecting
gas and electrical supply to range.
■ Note to Installer — Be sure to leave these
instructions with the consumer.
■ Note to Consumer — Keep these instructions with
your Owner’s Manual for future reference.
■ This backsplash adjusts to fit the space between the
top of the range and the bottom of the hood, from
30” Min. to 36” Max. height.
■ Maximum shelf load-bearing weight is 40 lbs.
Installation
Instructions
TOOLS AND MATERIALS REQUIRED
■Glovestoprotectagainstsharpedges
■T-15and#2Phillipsscrewdrivers
■Drillwith3/32”and9/64”bits
■Safetyglasses
■Level
■Pencil
This Kit Includes
■Topwallsupport
■Bottomwallsupport
■Topcoverwithshelf
■Bottomcover
TOOLS AND MATERIALS REQUIRED
(Cont.)
■Hardwarepackagewith
–9StainlessSteelTorx15
#8self-tappingscrews
–9Phillips#2panheadwood#10screws
–3StainlessSteel#2trusshead#10screws(for
alternate installation method)
Hardware
Package
761Dia65
Top Cover
with Shelf
Bottom Cover
Bottom Wall Support
Top Wall
Support
INSTALL THE WALL SUPPORT PANELS
WARNING
The wall support panels must be
securely fastened to the wall. Failure to do so could
result in damage or personal injury.
IMPORTANT: This backsplash is designed to cover
the wall between the bottom of the hood and the top of
the range. The vent hood should be installed over the
rangetop or range before installing this backsplash.
■InstallandleveltheRange/Rangetopaccordingto
the product installation instructions.
■Removebacksplashpackagingandprotectivefilm.
■Locatewallstudsoneachside.Wherestudsarenot
available,plantousewallanchors(notprovided).
■Usealeveltopencil2horizontallinesonthewall,
one1/8”belowtheventhoodandtheother1/8”
abovetheRange/Rangetop.This1/8”spaceallows
the cover panels to overlap the wall supports.
■Securethetopwallsupportpaneltothewallwith4
wood screws, through the outermost studs.
■Use4woodscrewstosecurethebottomwallsupport
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels
will be covered by the top cover with shelf.
1/8”
Secure the
top panel
to the wall
with 4 wood
screws
1/8”
Secure the
bottom panel
to the wall
with 4 wood
screws
Wood
Screws
Center
Arrow
Wood
Screws
31-10692-101-18GEA
2 31-10692-1
UXADJB36PSS, UXADJB48PSS Accessory Installation
INSTALL COVER PANELS
See alternate method if side access is blocked.
■Holdthebottomcoveroverthebottomsupport
whiledrivingonescrew(provided)intoeachside.
■Placethetopcoverwithshelfoverthetopwall
support.Ifyouhaveaccesstothesides,securethe
panel with two screws on each side.
■Securethetopcoverwithshelftothetopsupport
with screws through the front of the panel, at the top
corners.Useonescrewoneachside.
INSTALL COVER PANELS (cont.)
ALTERNATE METHOD: When side access is blocked
■Installbottomcoveroverthebottomsupportwhile
driving one screw into each side.
■Holdtopcoverinplacewhilemarkingscrewlocations,
just below shelf support and onto bottom cover.
■Removetheshelfanddrilla9/64”diameterholein
the pencil-marked locations.
■Mountthetopcoveroverthetopsupportand
secure the front cover with screws through the
drilled holes on each side.
■Installscrewsthrougheachtopcorner.
Install
Screw
CoverPanel
Install
Screw
InstallCornerScrews
Mark Screw
Locationsfor
Alternate Method
InstallScrew
onEachSide
Shelf
InstallScrewinTopCorneronEachSide
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/