2. Aries
  3. 25009

Aries 25009 Installation guide

  • Hello! I have reviewed the provided installation manual for the ARIES 25009 Tube Door. This document provides a detailed guide to the installation process, including required tools, a parts list, and step-by-step instructions. I'm ready to assist you with any questions you might have about installing and maintaining these doors.
  • What tools are required for the installation?
    What should be done before starting the installation?
    How should the tube door be cleaned?
PAGE 1 • 25009-INS-RB • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For black finishes, mild soap may be used to clean the product.
Level of Difficulty
Easy
Scan
for helpful
install tips
INSTALLATION MANUAL 25009
Parts List
1Driver side door, back
1Passenger side door, back
4Lock nut, 8mm
4Flat washer, 8mm
2Rubber bushing
2Sheet metal screw, Phillips head
Tools Required
Ratchet Tor x, T4 0
Extension Tor x, T50
Socket, 13mm
ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 25009-INS-RB • PAGE 2
Step 1
Beginning on the rear passenger side,
remove the torque bolts on the hinges
with a T50 torx bit as done on the front
door.
Step 2
Locate the lower kick panel between
the front and rear doors and remove the
plastic cover.
Disconnect the dome light and safety
strap. Lift the door and place aside.
Step 3
Install the new tube door by sliding
the door pins into the factory hinges.
Secure the door with an 8mm flat washer
and lock nut. Snug the hardware,
but do not fully tighten.
PAGE 3 • 25009-INS-RB • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Step 5
Check the alignment of the locking door
latch with the striker plate inside the door
jam. This may need to be adjusted in
order for the door to close completely.
To adjust, use a T40 Torx bit to loosen
the bolts on the striker plate. Align with
the door latch, and once in alignment,
tighten the torque bolts.
Step 6
When the door is aligned, tighten
the hardware on the hinges.
Repeat steps 1 through 5 on
the passenger side of the vehicle.
Congratulations on the installation
of your new ARIES tube doors.
With the doors installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.
Step 4
Reattach the safety strap.
Before closing the door, attach the rubber
bushing to the inside of the door as shown.
The rubber bushing is attached with
using the supplied Phillips head sheet
metal screws.
/