Promate MotionFlux User guide

Page is loading ...

English

Introduction

MotionFlux is an indoor lighting solution that is perfect for many dark rooms or dimly lit areas all

around the house. It comes with a built-in rechargeable battery which means you can use it

without spending extra money or fumble with any disposable batteries. It will help you light up

dark indoor areas while enjoying money and energy savings in the process.

Packaging Contents

• MotionFlux

• User Guide

Specifications

• Battery Capacity: 800mAh

• Battery Type: Lithium-Ion

• Input: 3.7V

• LED Brightness: 40lm

• Motion Sensor Range: 3-5m

• Charging Time: 3 hours

• Usage Time: 7 hours

1

English

Features

• Auto-on and off: Built-in motion sensors ensure problem-free operation when it

comes to auto-switching on and off. The MotionFlux will turn back off after a certain

period of inactivity.

• Dedicated on/off switch: When you need its light to stay on indefinitely, you can

use the dedicated on/off switch to keep it turned on. Using the same switch, you can

also switch it off indefinitely.

• Rechargeable Battery: The MotionFlux uses a rechargeable 800mAh battery which

means you will no longer need to replace its battery every time it runs out of charge.

Just recharge it and you’ll be back to using it in no time at all.

Precautions

Please read all safety instructions and warnings thoroughly before using this product.

Improper use of this product may result in damage to this or attached products.

1. Do not disassemble the product or attempt to fix it.

2. Kindly use an original charging cable provided to charge the product.

3. Do not attempt to replace any part of this product or battery inside.

4. Do not crush, puncture, dispose of in fire, short the contacts or expose the product

to water or other liquids.

5. Do not store or use the product in a high-temperature environment, including

intense sunlight or heat.

6. Avoid drops, bumps, abrasions and impacts.

7. If there is any reason to believe that there is damage to the product, discontinue

use immediately.

8. If you find that the product is too hot, is emitting an odour, or is deformed,

punctured or exhibits any suspicious or abnormal behaviour, discontinue use

immediately and contact our customer service.

2

English

Appearance & Interface Description

1. LED Lights

2. Auto/On/Off Switch

3. Motion Sensor

1

2

3

English

Correct disposal of this Product

(Waste Electrical & Electronic Equipment (WEEE)

Your product is designed and manufactured with high quality materials and components

which can be recycled and reused.

This symbol means that electrical and electronic equipment, at their end of-life should be

disposed of separately from your household waste.

Please dispose of this equipment at your local community waste

collection/recycling center.

This product complies with European safety and electrical interference directives

This product does not contain environmentally hazardous materials (lead, mercury,

cadmium, hexavalent chromium and brominated flammable agents: PBB and PBDE).

Operation Instructions

1. Installation

Install MotionFlux in an area where it can serve the function of an

auto-shining light source for your own convenience. It comes with a rechargeable

battery, so you can use it without spending any extra money. Find an appropriate

mounting location that is free from extremely cold or hot temperatures.

Use screws that are fixed on the wall for mounting. You can also use the

provided sticker for installation.

2. Operation

Once mounted, you can start using the MotionFlux as needed. The amount

of time that the MotionFlux stays on will depend on how much charge it carries.

It can last for up to 7 hours if charged fully for 3 hours. If set to ON,

it will run down the battery and may last anywhere from a few minutes to

a few hours depending on how much charge is available. User discretion is advised.

4

Page is loading ...

Promate MotionFlux User guide

Related papers

Other documents