OZCO 30180 24″ – 4″x4″ T4-600 Post Anchor Operating instructions

Type
Operating instructions
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
Typical Installation
(T4-600 shown)
Installation Instructions,
Wood Post Anchors
30180 T4-600 24" 4x4
30160 T4-850 34" 4x4
30200 C4-850 34" 4x4
30380 T46-850 36" 4x6
30400 T6-850 36" 6x6
30700 MB-24 24" 4x4
Accessory-Deck Plate
50880 OD-T4 12"x12"
1
Installation Instructions, Wood Post Anchors
with 50880 Deck Plate
(T4-600 & T4850 ONLY)
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
[732]
28.83
30380
[914]
36
99
3.90
150
5.91
Overview
3
Installation Instructions, Wood Post Anchors
30400
149
5.88
[917]
36
30700
100
3.95
30180
102
4.04
[609]
24
30160
[863]
34.00
102
4.04
30200
109
4.29
[863]
34
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
Typical
4
Installation Instructions, Wood Post Anchors
notes:
post anchor may be driven into any desired depth.recommend using polyurethane adhesive on applications where securing holes are below
surface level to prevent post rot.
30160 shown
Post securing options
#12 x 1-1/4" panhead screw mounting holes (screws not included)
5/16 x1-1/4" Lag BoltsPolyurethane adhesive; 3-4 squeezes on chauk gun applicator inside "injection hole"
Panhead screws plus Polyurethane adhesive
injection & 5/16 lag screw hole
.39
.18
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
for use with the following ONLY
30180 T4-600 24" 4x4
30160 T4-850 34" 4x4
Accessory: 50880
5
Installation Instructions, Wood Post Anchors
309
12
plate can be painted to match black post
anchors with automotive spray can bedliner
44
1.75
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
for use with the following ONLY
30180 T4-600 24" 4x4
30160 T4-850 34" 4x4
post anchor fasteners not shown
when precise location
of post anchor is
required, use 4 spikes
(not included)
when precise location is required
6
Installation Instructions, Wood Post Anchors
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
sledge hammer
(not included)
scrap piece
post level #50740
(sold separately)
not installed
while driving
sledge hammer installation
7
Installation Instructions, Wood Post Anchors
check angle
every 1"
repeat
until 1/2 way
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
check angle
every 1"
repeat
until 1/2 way
JDK installation
8
Installation Instructions, Wood Post Anchors
jack hammer
(rental)
50880
(sold separately)
drive post anchor and plate
additional time to compact soil
as desired
post level #50740
(sold separately)
not installed
while driving
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
8x panhead screw
(not supplied)
Method 1: halfway depth with screws & adhesive
9
Installation Instructions, Wood Post Anchors
Tip
cut tip in "V" shape so
adhesive flows in 2
directions
polyurethane adhesive
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
8x panhead screw
(not supplied)
Method 2: ground level depth with screws
10
Installation Instructions, Wood Post Anchors
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
(4x) lag bolt
(not supplied)
Method 3: halfway depth with lag bolts
11
Installation Instructions, Wood Post Anchors
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
Method 4: full depth with adhesive
12
Installation Instructions, Wood Post Anchors
polyurethane adhesive Tip
cut tip in "V" shape so
adhesive flows in 2
directions
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
Idea's
13
Installation Instructions, Wood Post Anchors
V2.00 - Installation Instructions, Specifications and Project Plans are effective 5/20/2018 . This information is updated periodically
and should not be relied upon after 2 years from 5/20/2018 . Please visit OZCOBP.com to get current information.
Sloped Surface Installation
14
Installation Instructions, Wood Post Anchors
cut into surface for level post installation
sloped surface
post anchor fasteners not shown
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

OZCO 30180 24″ – 4″x4″ T4-600 Post Anchor Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI