QUICK OPERATION GUIDE CDBB-303BT
QUICK OPERATION GUIDE CDBB-303BT
No
Button Function / Option
1 CD Compartment Playback for audio CD’s
2 Volume Control Adjust volume
3 Stop / USB Stop playback / Press and hold to select USB playback
4 Power indicator RED indicator when turned ON
5 LCD Display Displays playback information
6 Bluetooth indicator BLUE indicator when turned ON
7 Mode (MP3 playback only) Repeat options; current, [MP3] directory, all or random
8 Radio tuning knob Radio station manual tuning
9 AUX and Headphone Input Connection for headphones or Auxiliary audio line in
10 Power switch Selector for AUX/CD, OFF and Radio
11 Previous Track Select previous track for playback
12 MP3 Folder - Move to previous MP3 folder
13 Play / Pause Play or Pause music playback
14 MP3 / Folder + Move to next MP3 folder
15 Next Track Select next track for playback
16 Radio and Bluetooth switch Selector for AM, FM radio or Bluetooth playback
17 USB Socket Insert USB drive for playback
QUICK OPERATION GUIDE CDBB-303BT
WHATS IN THE BOX
1 x CD BoomBox, 1 x Mains Power Cable, 1 x User Manual
INSERTING BATTERIES
- Disconnect the AC cord and insert 6 x C size batteries into the battery
compartment noting the correct polarity as shown inside the battery
compartment.
RADIO RECEPTION
- For best reception, fully extend the FM antenna to receive FM stations.
- For AM reception, as the BoomBox has an internal AM antenna you may need
to position for best reception.
RADIO OPERATION
- Switch selector to RADIO.
- Switch to either AM or FM.
- Rotate the TUNING knob to tune to your desired radio station.
- Adjust the sound level by rotating the VOLUME control.
- Turn the radio off, by selecting OFF.
CD OPERATION
- Switch selector to AUX/CD.
- Insert a CD disc and close the CD door. The unit will start reading the disc and
display the total number of tracks of the disc.
- To start playback, press the PLAY/PAUSE button.
- Adjust the VOLUME knob to the desired volume level.
- To stop playback, press the PLAY/PAUSE button.
SKIP MODE
- During Playback (or while paused), press the Next Track button to go to the
next track.
- During Playback (or while paused), press the Previous Track button to go to the
start of the current track.
- During Playback mode, press the Previous Track button twice to go to the
previous track.
QUICK OPERATION GUIDE CDBB-303BT
MP3/AUX IN CONNECTION
Note: A 3.5mm to 3.5mm audio jack cable is required (not supplied)
- Insert one side of the audio cable into the AUX line-out jack of your audio
device and the other end into your BoomBox.
- Turn the BoomBox ON and slide the selector to the AUX/CD position.
- Turn your Audio device ON and begin playback.
BLUETOOTH MODE
- Switch selector to RADIO and the other to BLUETOOTH. The POWER indicator
will turn ON and the BLUETOOTH indicator will begin flashing (pairing mode).
- Turn the Bluetooth Function ON on your Bluetooth device, e.g. Mobile Phone
or Tablet.
- Enable search or scan function to find your CDBB-303BT
- Select CDBB-303BT to pair the Boombox with your Bluetooth device. A
confirmation chime will then sound and the Bluetooth indicator will turn to
solid, rather than flashing.
- After successfully pairing, you can select the PLAY/PAUSE button on your
Bluetooth device to play the music wirelessly from the Boombox.
CD & MP3-CD OPERATION
- Switch selector to AUX/CD position. The POWER LED indicator will turn ON.
- Insert the CD or MP3-CD disc in the CD compartment and close the CD door.
The unit will start reading the disc and display the total number of folders (eg
F01) and then the amount of tracks (eg 015).
[Playback will then start automatically]
- Adjust the VOLUME knob to the desired volume level.
- To pause playback of the CD or MP3-CD, press the PLAY/PAUSE button once.
- To resume playing, press the PLAY/PAUSE button again.
- To stop playing the CD or MP3-CD, press the STOP button.
SKIP FOLDER MODE (For MP3-CD only)
- During Playback (or while on pause), press the MP3 Folder + button to go to
the next folder.
- During Playback (or while on pause), press the MP3 Folder - button to go to
the previous folder.
QUICK OPERATION GUIDE CDBB-303BT
MODE BUTTON (REPEAT OPTIONS for MP3 and CD)
During playback, press the MODE button to display the following options.
Number of presses
Display
Function
Press once
Display
“
RE
P 1
”
Playback current track
Press twice
Display
“REP DIR”
(For MP3
-
CD
on
l
y
)
R
epeat one folder
Press three times
Display
“REP ALL”.
Repeat whole
CD
Disc
Press
f
our times
Display
“
RAN
”
(For MP3
-
CD
on
l
y
)
Random playback
Press
five
times
[no display options]
Repeat options canc
e
l
led
USB OPERATION
- Switch selector to AUX/CD then press and hold the STOP/USB button.
- Insert a USB drive containing MP3 music into the USB slot. The Boombox will
then start reading the USB and display the tracks contained.
[Playback will start automatically.]
- Adjust the VOLUME knob to the desired volume level.
- To stop playback, press the STOP button.
Note: If you want to switch to USB playing during CD playing, just press & hold
the Stop/USB button for few seconds, the Boombox will automatically switch
to the USB playing mode.
SPECIFICATIONS
Frequency Range: AM 530 - 1600 KHz, FM 88 - 108 MHz
Power Supply: AC 240V ~ 50Hz, or 6 x C size batteries
For further product information and instructions please visit our product web
page at www.laserco.com.au or email www.laserco.com.au/supports/email.php
Please note: As continuous improvements are made to this product, slight
operational differences may occur. For the most up-to-date user manual, please
visit our web site.
QUICK OPERATION GUIDE CDBB-303BT
Warranty Against Defects
Laser Corporation Pty Ltd (“Laser”) warrants your new product to be free from defects in materials
and workmanship for 12 months, from the date of purchase, provided that the product is used in
accordance with accompanying recommendations or instructions where provided. The benefit of this
warranty is in addition to your rights under the Australian Consumer Law and to other rights and
remedies of the consumer under a law in relation to the goods or services to which the warranty
relates.
Through a network of retailers and resellers, Laser will provide you with your choice of a repair,
exchange (where possible) or refund (within Dead on Arrival period) for this product if it becomes
defective within the warranty period.
This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse,
normal wear and tear, neglect or improper storage.
Please retain your receipt as proof of purchase.
How to make a product warranty claim:
Step 1: Find your receipt which proves the date of purchase. Where the date of purchase cannot be
verified, your place of purchase or Laser will make an assessment based on the date of manufacture,
the condition of the Laser product and the type of defect.
Step 2a): Contact your place of purchase. They will assess the nature of the fault and repair, replace
or refund the product as per their store refund or warranty policy.
Step 2b): If your place of purchase cannot be contacted, then you can contact Laser Customer
Service with details of your defective Laser Product Phone (02) 9870 3388; or Email:
[email protected] or online www.laserco.com.au/warranty (click on “Consumers (End Users)”).
Our business address is: Unit 1/6-8 Byfield Street, North Ryde, NSW 2113
Step 3: Laser will issue you with a Return Authorisation (RA) number within 48 hours. When
requested, send us the defective product and a copy of your receipt. Laser will cover the cost of the
return delivery.
Step 4: Wait for us to contact you. Once we have received your defective Laser product for
inspection, we will inform you of our assessment of your claim within 7 days. When we contact you,
we will firstly let you know whether you have a valid claim under this Warranty, and if so, we will
inform you whether your defective Laser product will be replaced or repaired, together with the
number of days you can expect to wait to receive your replaced or repaired Laser product.
Step 5: For further details on warranty cover and returns, please check Terms and Conditions for
Warranty Returns section at www.laserco.com.au/warranty (Consumers Section).
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You
are entitled to a replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
/