®Xiaomi: 10, 10 Pro, 9, 9Pro, Mix3, Mix2S;
2.Smart Watch:Apple： iWatch S1,S2,S3,S4,S5.
3. Earphone：
® Apple AirPods 2, Pro；
② Samsung Galaxy Buds, Buds+;
③ Huawei Freebuds2, 3; and more TWS (with wirelesscharging case).
6. Equipped with USB port, it can charge USB devices such as mobile phone,
electric tooth brush and portable power supply.
UV STERILIZER AND
WIRELESS CHARGER
Thank you for UVS Light Wireless Charger. Please read the instructions
carefully before using this product.
Product Introduction
The wireless charger. A compact charging house. Three devices can be charged
wirelessly using single line of power. With UV disinfection. Besides, it is
fashion that the light effect showing the charging state. The charger is so
space saving designed that can help you integrate your mobile phone
intelligent life very well.
Product Specification
Apple Watch 0utput:5W UV Light
Output: 3W (MAX) Input
Interface: lype-Cport
Prod Size: 187x90x80(mm)
Phone Output: 15W/10W/7.5W/5W
Earphone Output: 3W
Apple watch: 2.5W
USB Output： 5V/1A
Input: 9V/2A, 12V/2A
WPT: 110 – 239 KHz
Accessories List
UVS LightWirelessChargerx 1
Type-C quick charge cable xl
User manual xl
Applicable Devices
l. Smartphone: Compatible with 11 devices with Qi Standard. For all other
phones without Qi Standard, those will be working with wireless receivers.
Model:
©Apple: iPhone 11.11 Pro.11 ProMax, Xs, Xs Max, XR, X, 8, 8 Plus;
② Samsung: GalaxyS:20 5G.20+ 5G,20 Ultra 5G,10,10+,10e,9,9+,8, 8+,7,7
edge,6,6 edge,6 edge+, 6 G9209,6 Active: Galaxy Note: 10, lOe.10+,9,8,7,6,5;
③ Huawei: P:40Pro,30 Pro；Mate:30 5G,30Pro5G,30,30Pro,30 RS, 20 Pro,20 RS,RS;
Operation Steps
1. Connect the charger to a 9\^2A, 9V/2.7A or 12V/2A adapter through a
type-C quick charge cable to switch on the power;
3. Put the apple watch on and suck it up to charge;
4. put your earphone case on and charge;
5. If you want to turn off, turn on, or turn on the UV sterilization light,
just press the key.15 minutes disinfection mode: press the UV button fora
short time, enter into the sterilization modeforl5minutes, 15 minutes after
the automatic end of sterilization.
Double-click the key (to turn on/off)
LED light ring/Running water light
Click the key (to turn on/off)
the UVS light
LED light ring instructions
• Green light is on: Standby mode or not charging the phone ® Running water
light effect: Wireless charging the phone
• Red light flash： Foreign body is detected or the phone is misalign
(The phone charging will automatically stop)
Attention
1. Do notdisassemblethe product by yourself.
2. Please keep the charger away from water or other liquid;
3. If you need to clean the charger, please make sure it is not switched on the
power;
4. Using Environment temperature remains -20~50°C;
5. The charging contact surface on the back of the phone shall not contain
metal substances, such as iron sheet, ring and metal protective case;
6. Children are not allowed to play with UV lights for a
longtime;
7. When using adapters below 9V/2A, the product will not work normally. When
charging four devices at the same time, 9W2A、9W2.7A or 12V /2A ad a pters a
recommended to ensure safe and efficient charging. If not use the appropriate
adapter .the charger may not charge phone fast, or may not charge 4 devices
simultaneously, or may even damage the charger).
C€ FC RoHS X
MADE IN CHINA
FCC Compliance Statement (Part 15.19 (3))
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Interference Statement (Part 15.105) Class B
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from which the receiver
is connected. • Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance 20 cm between the radiator and your body. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
