Lockwood Induro Mortice Lock Palladium Xtra Furniture User manual

Type
User manual
For ease of use separate
template from instructions.
Template
Ø18mm HOLE
60mm
45mm
122mm
85mm
Ø16mm HOLE
19.5mm
Ø11mm HOLE
Ø11mm HOLE
Ø11mm HOLE
Q50285_1121
Tools required:
Drill
11mm, 16mm & 18mm Drill bit
Square #1 Screwdriver
Application: Compatible with Induro
Hinge Door Mortice Locks. Provides
daylatch snib.
Installation instructions
Position template on door.
Mark and drill holes for cylinder,
spindles and furniture mounting
as shown.
If mortice lock is fitted, loosen cylinder fixing screw.
Insert the drive bar through the square drive hole in the lock.
Place the interior handle onto the drive bar on the internal side of door.
Insert the Snib into the square drive hole at the top of the lock. The snib
lever must point away from the front of the lock, as shown.
Snib lever
Cylinder
fixing screw
Insert snib
InduroTM Mortice Lock
Palladium Xtra Furniture
Door preparation
Inserting snib in lock
For ease of use separate
template from instructions.
Template
Ø18mm HOLE
60mm
45mm
122mm
85mm
Ø16mm HOLE
19.5mm
Ø11mm HOLE
Ø11mm HOLE
Ø11mm HOLE
Turn key
to throw
deadbolt
Snib
Q50285_1121
ASSA ABLOY Australia Pty Limited
235 Huntingdale Rd, Oakleigh, VIC 3166
ABN 90 086 451 907 ©2019
1300 LOCK UP
www.yalehome.com.au
Place the external furniture on
the drive bar.
Fix secure furniture using two
M4 screws. See screw chart to
determine correct length.
Tighten cylinder fixing screw if
previously loosened.
Screw selection:
Screw Stile Width
M4 x 49mm 38 - 43mm
M4 x 55mm 43 - 49mm
M4 x 60mm 46 - 55mm
M4 x 65mm 55 - 58mm
Push the snib towards the front
of the door to lock off furniture
The snib can be retracted by
turning the key to throw the
deadbolt or by by pushing the
snib lever away from the front of
the door
Fixing furniture
Furniture operation
  • Page 1 1
  • Page 2 2

Lockwood Induro Mortice Lock Palladium Xtra Furniture User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI