Kindermann 4013000310 Installation guide

  • Hello! I'm a chat assistant, and I've reviewed the mounting instructions for the Kindermann Antikollisionssensor 4013000310. This document details the components included, such as the anti-collision sensor, cable holder, signal splitter, and RJ45 cables. The instructions emphasize that assembly should be carried out by qualified personnel, and defective components should not be used. I'm here to help if you have any questions about the mounting process or the included parts.
  • What is included in the scope of delivery?
    Who should perform the assembly?
    What should be done with defect components?
Antikollisionssensor für DisplayLift / Antikollisionsensor for DisplayLift
Art.-Nr./Ref. No. 4013000310
Montageanleitung
Mounting instructions
06.2022
EN
D
Lieferumfang /
Scope of delivery
Benötigte Werkzeuge /
Tools needed
2x M4 x 12 (3)
Schrauben / Screws
1x RJ45-Kabel
1x RJ45 cable
1x Kabelhalterung (selbstklebend)
1x Cable holder (self adhesive)
1x RJ45 90° Adapter
1x RJ45 90° adapter
1x Antikollisionssensor
1x Antikollisionsensor
1x Signal-Splitter
1x Signal splitter
! Sicherheitshinweise / Safety instructions
Bitte diese Anleitung sorgfältig durchlesen und
aufbewahren.
Aufbau und Montage sollen durch qualifizierte
Personen durchgeführt werden.
Bitte installieren Sie alle Komponenten wie ab-
gebildet.
Defekte Bauteile dürfen nicht verwendet werden
Please read these instructions carefully and keep
them for future reference.
Assembly shall be done by qualified persons only.
Please install all components as shown.
Defective components must not be used
3
Montageanleitung
Mounting instructions
4013000310 D/EN 2022-06 / 842 229 Änderungen vorbehalten / Subject to alterations Printed in Germany
Kindermann GmbH • Mainparkring 3 • D-97246 Eibelstadt • E-Mail: info@kindermann.de • www.kindermann.com
3
5
4
1
Ohne Antikollisionssensor /
Without Antikollisionsensor
Mit Antikollisionssensor /
With Antikollisionsensor
2x M4 x 12 (3)
3-5 cm
2
3
/