Start charging
with Point Go
-MP100
Quick guide to use
Diseño y contenido
WIP
Know your Point Go
Card reader with
chip card reader
Contactless
card reader
On / Off On /
Off button
Reset
Enter of
Cargador
Support
Chargin
g light
for strap
Green: the payment was
successful.
Red: payment could not
be payment could not be
processed.
Blue: the reader turned
on correctly.
Flashing blue: the reader
is ready to connect to
a cell phone.
Red side: low battery,
connect it to a power
source.
Status lights
Card reader
magnetic
Diseño y contenido
WIP
Activate Bluetooth
of your cell phone.
You can do it from the menu
drop-down menu of your cell
phone. If it is Android, you
will also need to activate the
location.
3
Charge your reader and
turn it on Connect it to a
power source
until the white side light
stops flashing and is xed.
and is xed. Then, turn it on
by pressing and holding
the Power button.
Connect your reader
1
Connect the reader
Go to "Cash with Point".
from the app and select
the Point Go reader.
When connected, the
flashing blue light will be
xed.
4
You can start getting paid
now You will receive the
money from your sales in
your sales in your Mercado
Pago account.
Check our frequently asked
questions at www.mercadopago.com
.ar/ayuda/point
Listo!
When you open it, register or log in.
Download the app
of Mercado Pago
with your Mercado Pago or
Mercado Libre account.
2
Diseño y contenido
WIP
How to
make a
collection?
I opened the Mercado
Pago app
Payment app and select
Collect with
Point.
Enter the amount of the
sale or select an item
from
item from Your Products.
Insert, swipe or tap the
card to the
card to the reader.
You're done! Your reader
will light up green to let
you know the payment
has been confirmed.
You will be able to send the
receipt to your customer by
SMS or e-mail.
1
2
3
4
Card reader
Card reader
with magnetic stripe
Chip card reader
contactless
Diseño y contenido
WIP
Diseño y contenido
WIP
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
FCC compliance statement
received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party
responsible for compliance could void the user s authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without
restriction.
/
