Buffalo Technology WLE-POE-S User manual

Brand
Buffalo Technology
Model
WLE-POE-S
Category
Power supply units
Type
User manual

Buffalo Technology WLE-POE-S is an adapter for supplying power to AirStation devices. This product enables compatible AirStations or AirStations with a compatible POE Receiver Adapter to be used in locations that are not provided with a nearby power source. It can be used with IEEE802.3af POE Receiver Adapters. The WLE-POE-S Power Supply Adapter uses the IEEE802.3af standard and injects 48V over the CAT5 cable. It has a maximum output current of 0.3A and a maximum current consumption of 250mW.

Buffalo Technology WLE-POE-S is an adapter for supplying power to AirStation devices. This product enables compatible AirStations or AirStations with a compatible POE Receiver Adapter to be used in locations that are not provided with a nearby power source. It can be used with IEEE802.3af POE Receiver Adapters. The WLE-POE-S Power Supply Adapter uses the IEEE802.3af standard and injects 48V over the CAT5 cable. It has a maximum output current of 0.3A and a maximum current consumption of 250mW.

■ NOTE: The WLE-POE-S Supply Adapter must be used with a compatible
AirStation or POE Receiver when supplying power to the AirStation. Check the
specifications on Page 4 to verify compatibility.
Package Contents:
Power Over Ethernet Supply
Connecting to your
Power-Over-Ethernet Supply Adapter
(WLE-POE-S)
The WLE-POE-S Power Supply Adapter is an
adapter for supplying power the AirStation. Using
this product enables compatible AirStations or
AirStations with a compatible POE Receiver
Adapter to be used in locations that are not
provided with a nearby power source.
PY00-29024-DM20
◗ POE Supply Adapter 1
◗ Power Supply Cable 1
◗ Setup Guide 1
◗ Warranty Certificate 1
Precautions:
◗ Connect the AC adapter last.
◗ Always connect the POE-compatible AirStation to the POE port.
◗ The Receiver and Supply cannot be attached by CAT5 longer then 100M.
◗ Use POE CAT5 cables (all eight wires)
◗ Use commercially available CAT5 cables. Using cables prepared by the
user may result in the network configuration not functioning properly.
◗ The products will become warm during use; this does not indicate
malfunction.
Screw holes
POE ports
Connect to the POE-compatible AirStation
or WLE-POE-R Adapter.
Air vents
AC Adapter
Power indicator
Lit green when the product is connected
to the AC outlet.
LAN port
Connect to hub,etc.
2
■ NOTE: DO NOT connect a hub or PC to the product's POE port. Doing so
may result in damage or burnout of the hub or PC Connect a POE-compatible
AirStation or a compatible POR Receiver Adapter to the POE port.
Supplying Power to a POE-compatible AirStation
◗ Connect the POE-compatible AirStation to the POE port using CAT5 cable.
◗ Connect the hub or PC to the Power Supply Adapter's LAN port.
◗ Connect the AC adapter to the AC outlet.
Installation
LAN cable
AC adapter
WLE-POE-S
(power supply adapter)
AC outlet
Hub,etc.
LAN port
WAN port
Use CAT 5 cable
POE- compatible
AirStation
Supplying Power to non-POE-compatible AirStations
◗ Connect the hub or PC to the LAN port of the WLE-POE-S Power Supply
Adapter.
◗ Connect CAT5 cable between the POE ports of the WLE-POE-S Power Supply
Adapter and the WLE-POE-R33/R7 Receiver Adapter.
◗ Connect the AirStation to the LAN port of the WLE-POE-R33/R7 Receiver
Adapter.
◗ Connect the AC adapter of the WLE-POE-S Power Supply Adapter to the
power outlet.
DC Connector
AirStation
LAN port
LAN port
AC outlet
POE port
POE port
Use CAT 5 Cable
Hub,etc.
LAN cable
AC adapter
DC cable
WLE-POE-S
(power supply adapter)
WLE-POE-R Adapter
3
■ NOTE: Using a cable other then CAT5 may prevent the supply of power to the
AirStation. Also, the POE receiver does not have a repeater function. Thus, the
total length of cable allowed between the Power Supply Adapter and the POE
Receiver is 100 meters.
Compatible AirStations
◗ POE-compatible AirStations
* WLM-L11G
◗ Non-POE-compatible AirStations (These models require the WLE-POE-R33/R7 Receiver
Adapters, sold separately.)
* WBR-G54 * WLA-L11G
* WBR2-G54 * WLA-AWCG
* WHR3-G54 * WLA-AWCG
* WLA-G54 * WLAR-L11G-L
* WLA-G54C * WLAR-L11-S
* WLA2-G54 * WLAR-L11-M
* WLI-TX1-G54
* WLI2-TX1-G54
◗ Compatible POE Receiver Adapters
* WLE-POE-R33 (For 3.3v AirStation Products)
* WLE-POE-R7 (For 7v AirStation Products)
■ NOTE: The WLE-POE-S Power Supply Adapter uses the IEEE802.3af
standard and injects 48V over the CAT5 cable. The WLE-POE-S Power Supply
Adapter can be used with IEEE802.3af POE Receiver Adapters. However, it is
recommended to always use the WLE-POE-R33 or WLE-POE-R7 POE Receiver
Adapters in conjunction with Buffalo AirStation products.
Connections
4
Specifications
Transmission Rate
100 Mbps
(100BASE-TX)
10 Mbps (10BASE-T)
Connector RJ-45 modular connector
POE Port 100BASE-TX / 10BASE-T dual purpose port
(for connecting the POE Receiver Adapter)
LAN Port 100BASE-TX / 10BASE-T dual purpose port
(for connecting a hub or PC)
Input Power Supply (AC) 100 to 240 VAC, 50/60 HzV
Output Power (POE) 48 VDC
Maximum Output Current 0.3A
Maximum Current
Consumption
250mW
Operating Environment Temperature: 0 to 40 degrees C
Humidity: 20 to 80% (non-condensing)
Dimensions (mm) 109 (W) x 23 (D) x 45 (H)
Weight
240g
Specifications
5
FCC Statement
This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case, the user will be required to correct the interference at
his own expense.
◗ All rights for this setup guide are owned by Buffalo INC. No part of it may be
transmitted, reproduced, or revised without expressed permission from BUFFALO
INC.
◗ The names of other products used in this manual are trademarks or registered
trademarks. Trademark symbols are not indicated in this setup guide.
◗ Specifications, designs and other descriptions in this manual are subject to
change without notice.
◗ This setup guide has been carefully prepared, however, feel free to contact
technical support if you have any questions or problems.
In addition, please note that Buffalo INC. shall not be liable for any expenses
incurred due to damage or loss arising from use of this product, even though
BUFFALO INC. has been advised of the possibility of such damage.
◗ This product is designed for home or office use as a general-purpose OA
device. BUFFALO INC. shall accept no liability for any damage incurred by using
the product for any other purpose.
FCC Statement
* Do not use the product for applications that must comply with high safety
requirements, such as medical instruments or any systems directly or
indirectly related to saving or sustaining life.
* If using the product for applications with devices and computer systems
requiring higher reliability than general-purpose OA devices, be sure to
configure the system with an appropriate safety design and measures
against failure.
6
  
          
           
           
         
          
              
         
  
          
            
           
            
           
    
             
             
              
            
         
               
                  
               
              
             
            
   
          
     
   
     
  
  
 
 
 
7
Notes
This page intentionally left blank.
Technical Support is available 24 hours a day, 7 days a week
(USA / Canada)
Toll-Free: 866-752-6210
email: [email protected]
©2004, Buffalo Technology (USA), Inc.
4030 W. Braker Ln. Suite 120
Austin, Texas 78759
Tel: 800-456-9799
Fax: 512-794-8606
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Buffalo Technology WLE-POE-S User manual

Brand
Buffalo Technology
Model
WLE-POE-S
Category
Power supply units
Type
User manual

Buffalo Technology WLE-POE-S is an adapter for supplying power to AirStation devices. This product enables compatible AirStations or AirStations with a compatible POE Receiver Adapter to be used in locations that are not provided with a nearby power source. It can be used with IEEE802.3af POE Receiver Adapters. The WLE-POE-S Power Supply Adapter uses the IEEE802.3af standard and injects 48V over the CAT5 cable. It has a maximum output current of 0.3A and a maximum current consumption of 250mW.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents