Installation Instructions for
Crest Flush Mounts
1.0
980CRESTC
Ceiling
894, _LEDFM FM895, FM896
Install the Mounting Plate
1
1A
1
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
This fixture are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low voltage electronic dimmer.
This product may be ceiling or wall mounted.
Separate the fixture base from the shade by unscrewing
and removing the three fixture screws using an Allen
wrench.
FIXTURE
SCREW
1
ALLEN
WRENCH
SHADE
MOUNTING
PLATE
1B
22
Remove the mounting plate from the fixture base by
unscrewing the two knurled nuts from the two threaded
studs.
2
KNURLED NUT
FIXTURE
BASE
1
2
FIXTURE
BASE
THREADED
STUD
3
1C
MOUNTING
PLATE
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Mount the mounting plate to the electrical box with the
two #8-32 screws.
#8-32 SCREW
4
#8-32 SCREW
ELECTRICAL
BOX
4
4
3
2
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2016 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
A Generation Brands Company
SAVETHESE INSTRUCTIONS!
9
10
FIXTURE
SCREW
Feed the driver, wires, and wire nut connections back
through the fixture base center hole and into the
electrical box.
While supporting the shade from the outer ring, align
the holes on the shade with the holes on the fixture
base. SecureDo not support from inner metal disc.
the fixture in place by tightening the three fixture
screws using an Allen wrench.
1F
10
10
ALLEN
WRENCH
5
Feed the driver and power line wires through the fixture
base center hole.
Install the fixture base onto the mounting plate studs
and secure it in place with the knurled nuts.
1D
FIXTURE
BASE
7
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
1E
DRIVER
7
FIXTURE
BASE
8
8
DRIVER
6
6
KNURLED NUT
THREADED
STUD
6
-
1
-
2
LBL Lighting FM896SCLED930 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
LBL Lighting LP1039ABLEDWD Installation guide
-
-
-
-
-
-
-
-
-
