LBL Lighting FM927OYWHLED930 Installation guide

LBL Lighting
Brand
LBL Lighting
Model
FM927OYWHLED930
Type
Installation guide
Installation Instructions for
Tenur Square Flush Mounts
1.0
980TENURSC
Ceiling
FM926, FM927
Install the Mounting Plate
1
1A
1
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic dimmer.
This product may be ceiling or wall mounted.
Loosen (do not remove) the two set screws on the
fixture using the provided Allen wrench.
Separate and remove the mounting plate from the back
of the fixture by sliding it out of the brackets.
3
2
For Tenur 9 Only: Secure the mounting plate to the
electrical box with the two #8-32 screws. Skip to step
1F.
For Tenur 12 Only: Temporarily install the mounting
plate to the electrical box with the two #8-32 screws.
BRACKET
MOUNTING
PLATE
FIXTURE
ALLEN
WRENCH
SET
SCREW
1
1
2
1B
MOUNTING
PLATE
ELECTRICAL BOX
#8-32 SCREW
3
#8-32 SCREW
3
1D
2
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2016 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
A Generation Brands Company
SAVETHESE INSTRUCTIONS!
9
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
Properly places all wires and wire nut connections into
the electrical box and reinstall the fixture to the
mounting plate (reversal of step 1A).
10
11
Mark the two anchor locations and uninstall the
mounting plate from the electrical box.
4
At the marked location, push the anchor in up to the
threads.
Screw the anchor the rest of the way in with a
screwdriver.
Reinstall the mounting plate to the electrical box.
ANCHOR
5
6
5
6
1C
7
1E
Secure the mounting plate to the anchors with the
washers and anchor screws.
8
1F
12
MOUNTING
PLATE
4
4
8
8
ANCHOR
SCREW
WASHER
1011
9
  • Page 1 1
  • Page 2 2

LBL Lighting FM927OYWHLED930 Installation guide

LBL Lighting
Brand
LBL Lighting
Model
FM927OYWHLED930
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents