New England Arbors CLASSIC 4x4 Sutton Garden Bed Installation guide

Type
Installation guide

This manual is also suitable for

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346, ext #20
(Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Post Caps (4)
2. Posts (4)
3. Side Panels (8)
4. 3.5” Stainless Steel Screws (16)
General Information
Read Instructions through carefully before beginning assembly.
When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
We recommend an area approx 4’x 8’ for unobstructed assembling.
You should not need to use excessive force when assembling components.
4’ x 4’ Raised Planter Bed
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
4
1
Not to Scale
3
2
Ver 1.0/MAR 2013
1
4 x 4 Raised Planter Bed
3605 32nd st., Building 3, Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
3
4
2
STEP O NE
Excavate four, 8-inch holes in a square pattern (4 x49½”)
as shown aside. Holes are to be 10 inches deep.
Place a post into each of the four holes. The posts will be buried
10 inches into the ground.
Stack the side panels two high between the posts.
While ensuring the posts and side panels are level, replace the
excavated dirt back and around the holes.
Using the screws provided, fasten the side panels to the posts.
(One screw for each intersection of side panel and post).
Pressure fit a post cap onto each of the posts.
Raised Bed Installation
1
2
1
2
10
8”
49½
49½
3
4
5
5
  • Page 1 1
  • Page 2 2

New England Arbors CLASSIC 4x4 Sutton Garden Bed Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI