2. CMP
  3. NEXXUS™ 4-BUTTON CONTROL

CMP NEXXUS™ 4-BUTTON CONTROL Operating instructions

  • Hello! I've reviewed the user manual for the CMP Bath Control System, specifically models 26400-100-101 and 26400-102-111. This system features electronic controls for customizing your bathing experience, including pump, blower, and pulse/wave functions, as well as a purge cycle. I'm ready to answer your questions about how to operate and troubleshoot your system.
  • What should I do if the Pump does not turn on?
    Why does the Blower come on by itself?
    What should I do if the Blower does not turn on?
WWW.CMP.COM
1117ab
BATH CONTROL SYSTEM
OPERATING INSTRUCTIONS
Your whirlpool bathtub has been equipped with Electronic Controls to provide
features that allow you to customize your bathing experience to your individual
preference. Please familiarize yourself with the features and operating
instructions below in order to maximize the enjoyment you receive from your
bath. These operating instructions should be used in conjunction with the other
instructions and warnings provided with your whirlpool bathtub in order to fully
understand and safely utilize the bathtub.
TABLE OF CONTENTS
1. OPERATING INSTRUCTIONS
2. TROUBLESHOOTING & FAQ
Power Pump Blower Pulse/Wave
CONTROL PAD LAYOUT
Instructions for Controller Heads:
26400-100-101
26400-102-111 ®
TM
2
1. OPERATING INSTRUCTIONS
1. Power (Activate System)
a. Tap Power button to turn ON control head.
b. Tap Power button again to turn OFF.
2. Pump
a. Tap Pump button to turn ON.
NOTE: If water level is too low, pump will not activate.
b. Tap Pump button again to turn OFF.
3. Blower
a. Press and hold Blower button for ~2 seconds to turn ON. The Blower will start
on the highest xed blower speed setting of “6”.
b. To adjust the “xed” blower speed setting, tap the Blower button. The Blower
has six xed speeds that can be adjusted from “6” to “1”.
c. Press and hold the Blower button to turn Blower OFF.
4. Pulse/Wave
a. With Blower on, tap Wave/Pulse button to turn ON Wave.
b. Tap again to switch to Pulse mode.
c. Tap again to switch back to Wave mode.
d. To exit Pulse/Wave mode, tap Blower button once to resume
Speed 6, or press and hold Blower button to turn OFF.
e. Purge/Clean Cycle: Fifteen minutes after the blower is turned o, the
blower will automatically activate for 2-3 minutes. During the purge cycle
the blower cannot be deactivated by touching any buttons on the control.
2. FAQ & TROUBLESHOOTING
1. What do I do if the Pump does not turn on?
a. Check water level.
b. Pump will not engage without a sucient water level.
2. What do I do if the Blower does not turn on?
a. Check electrical connections to the Blower.
4. Why does the Blower come on by itself?
Fifteen minutes after operation the blower will start a cleaning cycle to purge
the lines of water and dry the Blower tubes.. During this cycle the control pad
will not turn the Blower o when pressed. After three minutes the Blower will
automatically turn o.
For all other technical issues please contact CMP technical support through our
website www.c-m-p.com or by phone at 800-733-9060.
/