ACCESSORY INSTALLATION
INSTRUCTIONS
BENCH SEAT with BACKREST
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/07/2010
Rev: B
PROCEDURE NO.
AI-MS-010
1. PURPOSE
Provide step-by-step procedure for the bench seat
installation.
2. SCOPE
This procedure is limited to the bench seat installation on the
130, 150 & 170 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Drill
- 3/8” drill bit
5.2. Adjustable Wrench
5.3. Measuring Tape
5.4. Pencil
5.5. Hardware Pkg (supplied)
6. SAFETY
6.1. Safety glasses or goggles are recommended.
6.2. Remove battery and fuel tank
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
BENCH SEAT ................................................1950781
HARDWARE PKG.......................... 901BWSTORAGE
Page 1 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
BENCH SEAT with BACKREST
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/07/2010
Rev: B
PROCEDURE NO.
AI-MS-010
8. PROCEDURE
8.1 Place the seat on the bench making
sure the front edge of the seat aligns with
the front edge of the bench.
NOTICE
To avoid throttle interference when
operating the boat leave 1 ¾” space
between the throttle and the seat
when installing on the 130SS.
Center the seat on the bench when
installing on the 150SS.
8.2 Using the pencil, mark the bench at each of the posts
under the seat.
8.2.1. Remove the seat from the bench.
8.3 Using the drill with the 3/8” drill bit, drill through the bench
At each of the marks made in the previous step.
Page 2 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
BENCH SEAT with BACKREST
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/07/2010
Rev: B
PROCEDURE NO.
AI-MS-010
8.4 Using the adjustable wrench & the hardware provided,
secure the seat to the bench with a fender washer, lock
washer and nut on each of the posts.
8.5 Replace battery and fuel tank.
Bench Seat Installation Is Complete
Page 3 of 3
Page 3 of 3
/