Silhouette SR001 The Renoir Installation guide

LOCATION FOR WALL OUTLET

TO REMAIN HIDDEN

ANTI-TIP BRACKET

MOUNT HOLES

INSTALLATION INSTRUCTIONS:

1. Use this template to mark where you wish the unit to be installed.

2. Ensure a 120v wall outlet is available the area indicated below if the

power cord is to be hidden.

3. Ensure a 10” (25cm) clearance on the top and both sides of the unit.

4. This unit can accomodate any baseboard mouldings with a maximum

height of 8.5” (22cm) and maximum thickness of 1.5” (4cm).

5. Follow the outline on this template to mount the anti-tip bracket.

We recommend securing the bracket into a minimum of two wall studs.

6. Remove this paper template.

7. Using two people position the template approximately 12 inches from

the wall. Plug the unit into the wall.

8. Lift and center the unit under the mounting bracket.

9. Secure the unit to the mounting bracket with screws provided.

0. Set the leveling legs.

TEMPLATE MUST ALIGN TO FLOOR

MUST ANCHOR INTO WALL STUD

5 ¾ in.

16 ½ in.

9 ½ in.

8 ⁄ in.

81 ¾ in.

80 ⁄ in.

4 ⁄ in.

This manual is also suitable for