Metra 82-3019 Operating instructions

Type
Operating instructions
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before cycling the ignition. Also, do not remove the factory radio with
the key in the on position, or while the vehicle is running.
82-3019
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 10/31/17 INST82-3019
KIT FEATURES
KIT COMPONENTS
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 7mm socket wrench • Drill (optional)
Chevrolet Camaro 2010-2015
Adapts an aftermarket 6x9” speaker to the factory rear speaker locations
• A) (2) Speaker adapter plates • B) (4) #8 x 3/4” Phillips screws
1. Remove rear lower and upper seats.
2. Remove both lower door jam plastic trims.
3. Remove both rear side trim panels.
4. Remove driver and passenger shoulder seat belts.
5. Remove side “airbag” plastic covers to expose (1) 7mm bolt on each side, then remove the bolts.
6. Remove the side window trims from both sides.
7. Remove (2) 7mm bolts exposed (one on each side).
8. Remove (4) push pins from the rear deck cover.
9. Unclip rear deck cover to remove.
10. Remove (1) 7mm screw from each speaker, then unplug and remove the speakers.
1. Attach the speaker to the speaker adapter plate using the hardware provided with the speaker.
2. Clip the speaker assembly into place and secure with the factory hardware.
3. (2) screws have been provided for additional support.
A B
DISASSEMBLY
KIT ASSEMBLY
Metra recommends MECP
certified technicians
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the
instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.
AxxessInterfaces.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 10/31/17 INST82-3019
INSTALLATION INSTRUCTIONS
82-3019
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
  • Page 1 1
  • Page 2 2

Metra 82-3019 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI